Sharp JW-21MN manual Setting procedure, 11-13

[4] Setting procedure

Set parameters of the master station following the procedure below.

			[ ] : See page in chapter 11
				[ 14 ]
		Start slave station PC operation
		Turn ON the power of master station PC		[ 14 ]
		Connect support tools		[ 14 ]
		Stop PC operation		[ 14 ]
				[ 14 ]
		Stop operation of data link (007777(8) =00(H))
①				[ 15 ]
		Set top address of the relay link area on the master station
②
		Set data link function (004002(8) =01(H))		[ 15 ]
③
		Set number of connecting stations		[ 15 ]
④	Set top address of relay link area on slave station 01 to 77(8) (at standard function)			[ 15 ]
		/number of offset bytes (at save memory function)
				[ 16 ]
⑤		Set top address of register link area on master stations
⑥	Set top address of register link area on slave station 01 to 77(8) (at standard function)			[ 17 ]
		/number of off set bytes (save memory function)
⑦
		Set number of sending bytes of the master station relay link		[ 17 ]
⑧
		Set number of sending bytes of the slave station 01 to 77(8) relay link		[ 18 ]
⑨
		Set number of sending bytes of the master station register link		[ 18 ]
⑩		Set number of sending bytes of the slave station 01 to 77(8) register link		[ 18 ]
⑪		Set connection status of slave stations		[ 19 ]
				[ 19 ]
⑫		Whether the station number information should be output or not
	V2
				[ 20 ]
⑬		Set top address of flag area
				[ 21 ]
⑭		Writing to EEPROM, start operation (007777(8) =81(H))
				[ 21 ]
		PC operation
		End

①to ⑭ are equivalent to number of page 11-5, and 11-6.

11

11-13