Indications in [ ] of each item mean as follows:
(Example) Stop operation of data link [HEX (hexadecimal), byte]
This means to set "stop operation" by hexadecimal and byte unit.
"Run" the slave station PC
Turn "ON" the power of the master station PC and connect support tools
Connect a support tool with the | |
| |
<Usable support tools> |
|
| |
| |
| |
- For operation of each support tool, see the instruction | |
manual attached. The following describes an example |
|
of
Note: Setting parameters is unavailable by
Stop PC operation
Turn to program mode (stop PC operation). Setting of parameters is only available when the PC is in program mode.
Stop PC operation
11
Select parameter setting mode.
Select initial mode
(Set parameter)
Stop operation of data link | [HEX (hexadecimal), byte] |
|
|
|
| ||
Write "00(H)" to parameter address 007777(8) and stop operation |
|
|
| ||||
of the | 007777(8) | 0 0(H) | |||||
when the operation of the |
|
|
|
| |||
|
| Screen display of |
| ||||
|
|
|
|
|
|
|
|
|
|
| 07775 | HEX | 00 |
|
|
Display the contents of parameter | Write | 07776 | HEX | 1F |
|
| |
I PARAM. |
|
|
|
| |||
(00(H). ) |
|
|
|
| |||
address 007777 by hexadecimals. | >07777 | HEX | 00 |
|
|
Reference Function of
• key: Changeover unit of figures
→HEX(hexadecimal) →OCT(octal) → DCM(decimal) →Bit pattern
- key: Byte display ←→ Changeover word display
To the next page