Sharp JW-21MN manual 11-25, Turn on the power of slave station PC Connect support tools

Indications in [ ] of each item mean as follows:

(Example) Stop operation of data link [HEX (hexadecimal), byte]

This means to set "stop operation" by hexadecimal and byte unit.

Turn "ON" the power of slave station PC

Connect support tools	(JW-14JG)
Connect a support tool with the JW-21MN.
<Usable support tools>
JW-14PG/13PG/12PG
JW-50SP	JW-21MN
JW-50PG, Z-100LP2S

-For operation of each support tool, see the instruction manual attached. The following describes an example of JW-14PG's key operation.

Note: Setting parameters is unavailable by JW-2PG.

Stop PC operation

Turn to program mode (stop PC operation). Setting of parameters is only available when the PC is in program mode.

Stop PC operation

Select parameter setting mode.

(Set parameter)

Select initial mode

Stop operation of data link	[HEX (hexadecimal), byte]
Write "00(H)" to parameter address 007777(8) and stop operation
of the JW-21MN. Setting of the parameter is only available						007777(8)
							0 0(H)
when the operation of the JW-21MN is stopped.
			Screen display of JW-14PG
		Write		07775	HEX	00
				07776	HEX	1F
Display the contents of parameter		（00(H).）
address 007777 by hexadecimals.				I PARAM.
				>07777	HEX	00

Reference Function of JW-14PG

- key: Changeover unit of figures

→HEX (hexadecimal) → OCT (octal) → DCM (decimal) →Bit pattern

- key: Byte display ←→ Changeover word display

To the next page

11

11-25