Cisco Structured
Implementing the Cisco SWAN Framework
You should also navigate to the Catalyst 6500 Supervisor
show mobility status
Enter this command to show the slot location of the WLSM, the LCP status, tunnel information, registered access points, registered mobile nodes, and important information about the tunnels:
sup720# show mobility status
WLAN Module is located in Slot: 1 (HSRP State: Not Applicable)
LCP Communication status: up
MAC address used | for Proxy ARP: 0008.2034.7400 |
| ||
Number | of Wireless Tunnels: 4 |
|
| |
Number | of Access | Points: 1 |
|
|
Number | of Mobile | Nodes: 3 |
|
|
Wireless Tunnel Bindings: |
|
| ||
Src IP | Address | Wireless | Trusted | Broadcast |
10.100.1.1 | 1 | No | Yes |
10.100.2.1 | 2 | Yes | Yes |
10.100.3.1 | 3 | Yes | Yes |
10.100.4.1 | 4 | Yes | No |
Enter the following command to show information about the registered access points:
show mobility ap
The IP addresses, MAC addresses, and appropriate network identifiers for the registered access points are shown:
sup720# show | mobility ap |
|
AP IP Address AP Mac Address | Wireless | |
10.200.20.49 | 000b.fcfb.e836 | 4 |
Enter the following command to show information about registered client mobile nodes:
show mobility mn
The MN MAC address, MN IP address, the IP address of the MN's current access point, and the network identifier of the MN is shown:
sup720# show mobility | mn |
|
| |
MN Mac Address | MN IP | Address | AP IP Address | Wireless |
0004.e28b.2c28 | 172.16.4.3 | 10.200.20.49 | 4 | |
00d0.59c8.60e1 | 172.16.4.2 | 10.200.20.49 | 4 |
Enter the following command to show information about a specific mobility group.
show mobility network
Cisco Structured
30 |
| |
|