Cisco Systems SOHO 77 manual Cisco 827 and Soho 77 Routers Hardware Installation Guide

Page 2

THE SPECIFICATIONS AND INFORMATION REGARDING THE PRODUCTS IN THIS MANUAL ARE SUBJECT TO CHANGE WITHOUT NOTICE. ALL STATEMENTS, INFORMATION, AND RECOMMENDATIONS IN THIS MANUAL ARE BELIEVED TO BE ACCURATE BUT ARE PRESENTED WITHOUT WARRANTY OF ANY KIND, EXPRESS OR IMPLIED. USERS MUST TAKE FULL RESPONSIBILITY FOR THEIR APPLICATION OF ANY PRODUCTS.

THE SOFTWARE LICENSE AND LIMITED WARRANTY FOR THE ACCOMPANYING PRODUCT ARE SET FORTH IN THE INFORMATION PACKET THAT SHIPPED WITH THE PRODUCT AND ARE INCORPORATED HEREIN BY THIS REFERENCE. IF YOU ARE UNABLE TO LOCATE THE SOFTWARE LICENSE OR LIMITED WARRANTY, CONTACT YOUR CISCO REPRESENTATIVE FOR A COPY.

The following information is for FCC compliance of Class A devices: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio-frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case users will be required to correct the interference at their own expense.

The following information is for FCC compliance of Class B devices: The equipment described in this manual generates and may radiate radio-frequency energy. If it is not installed in accordance with Cisco’s installation instructions, it may cause interference with radio and television reception. This equipment has been tested and found to comply with the limits for a Class B digital device in accordance with the specifications in part 15 of the FCC rules. These specifications are designed to provide reasonable protection against such interference in a residential installation. However, there is no guarantee that interference will not occur in a particular installation.

Modifying the equipment without Cisco’s written authorization may result in the equipment no longer complying with FCC requirements for Class A or Class B digital devices. In that event, your right to use the equipment may be limited by FCC regulations, and you may be required to correct any interference to radio or television communications at your own expense.

You can determine whether your equipment is causing interference by turning it off. If the interference stops, it was probably caused by the Cisco equipment or one of its peripheral devices. If the equipment causes interference to radio or television reception, try to correct the interference by using one or more of the following measures:

Turn the television or radio antenna until the interference stops.

Move the equipment to one side or the other of the television or radio.

Move the equipment farther away from the television or radio.

Plug the equipment into an outlet that is on a different circuit from the television or radio. (That is, make certain the equipment and the television or radio are on circuits controlled by different circuit breakers or fuses.)

Modifications to this product not authorized by Cisco Systems, Inc. could void the FCC approval and negate your authority to operate the product.

The Cisco implementation of TCP header compression is an adaptation of a program developed by the University of California, Berkeley (UCB) as part of UCB’s public domain version of the UNIX operating system. All rights reserved. Copyright © 1981, Regents of the University of California.

NOTWITHSTANDING ANY OTHER WARRANTY HEREIN, ALL DOCUMENT FILES AND SOFTWARE OF THESE SUPPLIERS ARE PROVIDED “AS IS” WITH ALL FAULTS. CISCO AND THE ABOVE-NAMED SUPPLIERS DISCLAIM ALL WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING, WITHOUT LIMITATION, THOSE OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND NONINFRINGEMENT OR ARISING FROM A COURSE OF DEALING, USAGE, OR TRADE PRACTICE.

IN NO EVENT SHALL CISCO OR ITS SUPPLIERS BE LIABLE FOR ANY INDIRECT, SPECIAL, CONSEQUENTIAL, OR INCIDENTAL DAMAGES, INCLUDING, WITHOUT LIMITATION, LOST PROFITS OR LOSS OR DAMAGE TO DATA ARISING OUT OF THE USE OR INABILITY TO USE THIS MANUAL, EVEN IF CISCO OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.

CCSP, CCVP, the Cisco Square Bridge logo, Follow Me Browsing, and StackWise are trademarks of Cisco Systems, Inc.; Changing the Way We Work, Live, Play, and Learn, and iQuick Study are service marks of Cisco Systems, Inc.; and Access Registrar, Aironet, ASIST, BPX, Catalyst, CCDA, CCDP, CCIE, CCIP, CCNA, CCNP, Cisco, the Cisco Certified Internetwork Expert logo, Cisco IOS, Cisco Press, Cisco Systems, Cisco Systems Capital, the Cisco Systems logo, Cisco Unity, Empowering the Internet Generation, Enterprise/Solver, EtherChannel, EtherFast, EtherSwitch, Fast Step, FormShare, GigaDrive, GigaStack, HomeLink, Internet Quotient, IOS, IP/TV, iQ Expertise, the iQ logo, iQ Net Readiness Scorecard, LightStream, Linksys, MeetingPlace, MGX, the Networkers logo, Networking Academy, Network Registrar, Packet, PIX, Post-Routing, Pre-Routing, ProConnect, RateMUX, ScriptShare, SlideCast, SMARTnet, StrataView Plus, TeleRouter, The Fastest Way to Increase Your Internet Quotient, and TransPath are registered trademarks of Cisco Systems, Inc. and/or its affiliates in the United States and certain other countries.

All other trademarks mentioned in this document or Website are the property of their respective owners. The use of the word partner does not imply a partnership relationship between Cisco and any other company. (0502R)

Cisco 827 and SOHO 77 Routers Hardware Installation Guide

Copyright © 2005 Cisco Systems, Inc. All rights reserved.

Image 2
Contents Cisco 827 and Soho 77 Routers Hardware Installation Guide Corporate HeadquartersCisco 827 and Soho 77 Routers Hardware Installation Guide Preface Using the Router LEDs to Check Links Conventions AudienceOrganization Preface Conventions Cisco.com Related DocumentationObtaining Documentation Documentation DVDOrdering Documentation Documentation FeedbackCisco Product Security Overview Cisco Technical Support Website Reporting Security Problems in Cisco ProductsObtaining Technical Assistance Submitting a Service Request Definitions of Service Request SeverityObtaining Additional Publications and Information Xii Product Overview Router Overview FeaturesFeature Routers Description Front Panels Router Ethernet Ports Telephone PortsBack Panels Cable lock Ethernet port Adsl port9and -10show the back panels of the Soho 77 routers OK LED LEDsColor Function Adsl TXD Adsl CDAdsl RXD EthernetPage Installation Preparing for Installation SafetyUnpacking the Box Preventing Electrostatic Discharge DamagePreventing Router Damage Mounting on a Wall Mounting the RouterMounting on a Table Installing the Router Mounting Router on a WallOUT MDI-X OUT Connect Ethernet DevicesMDI OUTButton NetworkRouter to Device Network Device Ethernet Cable OUT MDI-XConnecting Hubs Connecting a Server, PC, or Workstation Connecting an Adsl Line to a Wall Jack Connect an Adsl LineConnecting an Analog Telephone or Fax Machine Connecting a Terminal or PC Vendor Name Product Name For More InformationTo power supply Connect the AC AdapterEthernet 1, Ethernet Using the Router LEDs to Check LinksPower/Link LEDs to Check Normal Patterns Phone 1, PhoneUsing Cisco Router Web Setup to Configure the Router Configuring the RouterChecking the PC Configuration Installation Configuring the Router Page Problems During First Startup Before You Call Your Cisco ResellerHUB/TO PC SymptomSolutions Problems After Router Is Running Page Router Power Cisco 827H and Soho 77H System SpecificationsDescription Design Specification Physical Dimensions Environmental Operating RangesFunction To HUB/TO PC Button Pin Position OUT Position Port Connector PinoutsDescription Design Specification Telephone Port Power Cisco TX+ RX+Pin Function Unused ROF Cabling SpecificationsEthernet Cable Specifications RTN10BASE-T Maximum Cable DistancesType Category Shielding Cable Maximum DistanceNumerics Ethernet RXD LED Ethernet TXD LEDIN-2 IN-3 IN-4