Cisco Systems AVS 3120 Unpacking and Inspecting the AVS, Installing Your AVS

Chapter 3 Installing the AVS 3120

Unpacking and Inspecting the AVS 3120

Unpacking and Inspecting the AVS 3120

The AVS 3120 shipment contains the following items:

•One RJ-45 to female 25-pin sub-d connector

•One RJ-45 to female 9-pin sub-d connector

•One RJ-45 console cable

•Two 6-ft Ethernet cables

•One rack mounting kit—two metal brackets and screws

•Four rubber feet

•Cisco Product Documentation CD-ROM and Warranty Package

•Cisco AVS 3120 Application Velocity System Hardware Installation Guide

The AVS 3120 is shipped in a protective shipping carton. It is shipped as a self-contained chassis; no components can be added or removed.

Follow these steps to unpack the AVS 3120:

1.Remove the AVS 3120 accessories from the shipping carton. Save the packing materials in case you need to repack the AVS 3120 later.

2.Check the configuration of the AVS 3120 and the accessories against the items listed on the packing slip. Report any discrepancies as described in “If the Product is Damaged”.

3.Before installing the AVS 3120, review the information outlined in Chapter 2, “Preparing for Installation.”

If the Product is Damaged

If any portion of the unit or component is damaged in transit, forward an immediate request to the delivering carrier to perform an inspection of the product and to prepare a damage report. Save the container and all packing materials until the contents are verified.

Concurrently, report the nature and extent of the damage to Customer Service. Report the problem or deficiency to Customer Service along with the model number and serial number. Upon receipt of this information, you will be provided with service instructions, or a Return Material Authorization (RMA) number and shipping information. To obtain assistance, refer to the “Obtaining Documentation” section on page xiv.

Installing Your AVS 3120

Place the AVS 3120 in the desired location. You can mount it in a rack for your convenience, or place it on a solid, stable surface. If you do not plan to install the AVS 3120 in an equipment rack, proceed to the “Installing the AVS 3120 on a Workbench or Tabletop” section on page 3-5.

Racks are marked in vertical increments of 1.75 inches (4.45 cm). Each increment is referred to as a rack unit (RU). A 1-RU device is 1.75 inches (4.45 cm) tall.

Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment.

Statement 1030

Cisco AVS 3120 Application Velocity System Hardware Installation Guide

3-2 OL-11805-01