Chapter 3 Installing the AVS 3120
Removing or Replacing an AVS 3120
Removing or Replacing an AVS 3120
Warning Before working on a system that has an on/off switch, turn OFF the power and unplug the power cord. Statement 1
Warning Ultimate disposal of this product should be handled according to all national laws and regulations. Statement 1040
To physically remove an AVS 3120 from your network follow these steps:
1.Login to the shell as the root user and execute the poweroff command. To do this:
a.Access the CLI and open the shell by using the sysopen command:
velocity>sysopen
b.Change to the root user using the su command with the dash option:
c.Enter the root password (the default is FineGr0und5!):
password:
d.Execute the poweroff command:
2.Power down the AVS 3120 by turning off the power switch on the rear panel of the AVS 3120.
3.Disconnect the power cords and network cables.
4.Physically remove the chassis from the rack.
To physically replace an AVS 3120, install the new AVS 3120 and configure it using the same configuration parameters (such as the IP address) that you used for the removed AVS 3120. Refer to the Cisco Application Velocity System User Guide for configuration details.
| Cisco AVS 3120 Application Velocity System Hardware Installation Guide |
|