Cisco Systems ASASSMCSC10K9 quick start Enables Dhcp for the management host on

Command

Purpose

Step 2 Do one of the following to configure a management interface, depending on your mode:

Routed mode:		Configures an interface in routed mode. The
interface vlan number		security_level is a number between 1 and
		100, where 100 is the most secure.
ip address ip_address [mask]
nameif name
security-level level
Example:
hostname(config)# interface vlan 1
hostname(config-if)# ip address
192.168.1.1	255.255.255.0
hostname(config-if)# nameif inside
hostname(config-if)# security-level 100
Transparent mode:		Configures a bridge virtual interface and
interface bvi bvi_number		assigns a management VLAN to the bridge
		group. The security_level is a number
ip address ip_address [mask]
		between 1 and 100, where 100 is the most
interface vlan number		secure.
bridge-group bvi_number
nameif name
security-level level
Example:
hostname(config)# interface bvi 1
hostname(config-if)# ip address
192.168.1.1	255.255.255.0

hostname(config)# interface vlan 1 hostname(config-if)# bridge-group 1 hostname(config-if)# nameif inside hostname(config-if)# security-level 100

Step 3 dhcpd	address ip_address-ip_address	Enables DHCP for the management host on
interface_name		the management interface network. Make
dhcpd	enable interface_name	sure you do not include the management
		address in the range.

Example:

hostname(config)# dhcpd address 192.168.1.2-192.168.1.254 inside hostname(config)# dhcpd enable inside

8