Chapter 3 Installing the Cisco VG224 Voice Gateway
Wall-Mounting the Chassis
The following warning applies only when the unit is
Warning This unit is intended to be mounted on a wall. Please read the
Caution You can
Note For information about obtaining the chassis guard, refer to field notice number 28655, VG224 Chassis Guard - Safety Regulation, at
To
Step 1 Attach the short leg of one bracket to the chassis, as shown in Figure
Caution Be sure to use the correct screws and plastic washers for this mounting option. (See Table
Figure 3-7 Attaching the Brackets for Wall-Mounting
88843
Step 2 Attach the second bracket to the opposite side of the chassis.
Step 3 Attach the router to the wall using the brackets previously attached and attachment hardware that you provide as follows:
•You can install a starter screw in the wall, and hook the bracket keyhole over the screw. This holds the unit in place for easy installation of the attachment screws.
•Attach both brackets to the wall.
Cisco VG224 Voice Gateway Hardware Installation Guide
|
| ||
|
|