Accessory Kit to Use

Chapter 8 Installing and Upgrading Internal Modules in Cisco 1805 Cable Routers

Modules Internal to the Cisco 1805 Cable Router

Caution When you install an AIM, always wear an ESD-preventive wrist strap, and ensure that it makes good contact with your skin. Connect the equipment end of the wrist strap to the metal part of the chassis.

Caution Handle AIMs by the edges only. AIMs are ESD-sensitive components and can be damaged by mishandling.

Some AIMs are provided with multiple accessory kits that contain different configurations of mounting hardware. Mounting hardware for the Cisco 1805 cable router consists of two machine thread metal standoffs, two machine thread metal screws, and one plastic standoff.

To install an AIM module on the Cisco 1805 cable router, use the hardware in mounting kit 69-1316-01.

Installation Procedure

To install the AIM, perform the following steps. You need a number 2 Phillips screwdriver or flat-head screwdriver to complete this procedure.

Step 1 Find the metal standoff attachment locations on the system board near the AIM connector, indicated by a star pattern, as shown in Figure 8-7.

Figure 8-7 Location of Metal Standoff Attachment Locations

System board

121107

AIM connector

Step 2 Install the two metal standoffs from the accessory kit into the system board in the metal standoff attachment locations. Use a 1/4-inch nut driver to tighten the standoffs. Locations for AIM standoffs are denoted by a star pattern around the standoff mounting holes.

Caution Make sure that the standoffs are installed straight. Tighten them gently but firmly. The shoulder must be seated tightly against the system board.

Cisco 1805 DOCSIS Cable Router Hardware Installation Guide

	OL-14661-01	8-7