Cisco Systems 1805 manual Connecting the AIM to the System Board

Page 9

Chapter 8 Installing and Upgrading Internal Modules in Cisco 1805 Cable Routers

Modules Internal to the Cisco 1805 Cable Router

Figure 8-9 Connecting the AIM to the System Board

AIM

Snap-in plastic

standoff

Metal standoffs

121108

Step 4 Insert the connector on the AIM into the AIM connector on the system board. (See Figure 8-9.)

Note Be sure to press firmly on the AIM until the board seats onto the connector. The plastic standoff must snap into the hole in the AIM board. (See Figure 8-9.)

Step 5 Insert the screws from the accessory kit through the AIM into the metal standoffs. (See Figure 8-9.) Carefully tighten the screws with a Phillips screwdriver.

Step 6 Check that the AIM is installed correctly on the system board. (See Figure 8-10.)

Cisco 1805 DOCSIS Cable Router Hardware Installation Guide

 

OL-14661-01

8-9

 

 

 

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Safety Warnings Opening the Chassis Modules Internal to the Cisco 1805 Cable RouterRemoving the Chassis Screw Removing the Cover of the Cisco 1805 Router Locating ModulesCisco 1805 Cable Router Internal View Installing a SodimmRemoving a Sodimm Installing an AIMAccessory Kit to Use Plastic Standoff Orientation Connecting the AIM to the System Board Applying the AIM Label Closing the ChassisRotate cover onto router Slide cover onto router chassis OL-14661-01
Top Page Image Contents