Cisco Systems 1805 manual Plastic Standoff Orientation

Page 8

Chapter 8 Installing and Upgrading Internal Modules in Cisco 1805 Cable Routers

Modules Internal to the Cisco 1805 Cable Router

Step 3 Insert the plastic standoff (Figure 8-8) from the accessory kit into the hole in the system board. See Figure 8-9. Press the standoff firmly into the system board to be sure that it is locked to the board.

Note The plastic standoff snaps into the system board. Be sure to insert the locking end of the standoff into the system board. The locking end is the shortest end of the standoff. Figure 8-8identifies the locking end of the plastic standoff used with AIMs.

Figure 8-8 Plastic Standoff Orientation

AIM end

Locking end

82620

Cisco 1805 DOCSIS Cable Router Hardware Installation Guide

8-8

OL-14661-01

 

 

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Safety Warnings Modules Internal to the Cisco 1805 Cable Router Opening the ChassisRemoving the Chassis Screw Locating Modules Removing the Cover of the Cisco 1805 RouterInstalling a Sodimm Cisco 1805 Cable Router Internal ViewInstalling an AIM Removing a SodimmAccessory Kit to Use Plastic Standoff Orientation Connecting the AIM to the System Board Closing the Chassis Applying the AIM LabelRotate cover onto router Slide cover onto router chassis OL-14661-01
Top Page Image Contents