Emulex 110 manual Using a Microsoft Cluster Server

Page 30

6. Using a Microsoft Cluster Server

If you are using a Microsoft Cluster Server, any shared cluster storage must look identical to all clustered servers. Ensure that this is the case by doing the following:

1.After the HBA is installed, run the Emulex AutoPilot Manager utility.

2.From the View menu, select Advanced Mode.

3.Click the Target Mapping tab.

4.Verify that, for any shared storage that is available to all clustered systems, the D_ID, SCSI_ID and Type settings in the Current Mapping section are identical for all shared devices.

NetWin 110 HBA User’s Guide

Page 6-1

Image 30

Contents NetWin 110 HBA NetWin 110 HBA User’s Guide Using the AutoPilot Manager Utility Using a Microsoft Cluster ServerCannot See New LUNs Windows HBA Status LEDs Overview Using the AutoPilot Manager Utility Starting the AutoPilot Manager UtilityAutoPilot Manager Utility Elements Menu BarToolbar Discovery Tree Property Windows and Property PagesStatus Bar Discovering SAN Elements Modifying Discovery PropertiesViewing the Discovery Summary Viewing Host InformationManaging Host Bus Adapters Sorting HBAsResetting an HBA Reverting to an HBA’s Default NameEditing an HBA’s Name Viewing an HBA’s General Information Viewing Fabric Information Viewing Target InformationAdvanced Mode Operation Upgrading Firmware and Enabling x86 BootBIOSViewing LUN Information Enabling or Disabling x86 BootBIOS Updating FirmwareAuto-Persistent Binding Changing Current SettingsMapping Targets and Editing Persistent Bindings Current MappingsPersistent Binding Configuration Updating Drivers Updating a Driver for WindowsBios Utility Configuration Guide Starting the Bios UtilityEnabling the Bios on an HBA Changing the Default AlpaChanging the Plogi Retry Timer Enabling and Disabling the Spinup Delay Changing the TopologySetting Auto Scan Enabling and Disabling EDDEnabling and Disabling the Start Unit Command Enabling and Disabling the Environment VariableEnabling and Disabling Auto Sector Format Select Configuring an Installed Drive As a Boot Device NetWin 110 HBA User’s Guide Installing Windows on a New Boot Device NetWin 110 HBA User’s Guide Using a Microsoft Cluster Server Page Hardware Reference SpecificationsLaser Safety Notice Certification and ClassificationLabeling Requirements Product InformationNetWin 110 HBA User’s Guide B-2 Usage Restrictions Small Form Factor Transceiver1x9 Transceiver NetWin 110 HBA User’s Guide B-3System Level Certification NetWin 110 HBA User’s Guide B-4AutoPilot Manager Utility Cannot See Other HBAs or Hosts TroubleshootingSCSIport Miniport Driver Does Not See Targets Cannot See New LUNs WindowsHBA Status LEDs NetWin 110 HBA User’s Guide C-2