Cabletron Systems HSIM-G01 manual HSIM-G09 Connection Using Multimode Cable

Page 23

Connecting to the Network

To remove the SC connector, from the HSIM-G, carefully pull the connector out of the port. It may need to be wiggled gently to release the latching keys.

If a link has not been established, refer to Chapter 3 before contacting Cabletron Systems. Refer to Section 1.3 for details on getting help.

2.3.2HSIM-G09 Connection Using Multimode Cable

NOTE

When using premises multimode fiber cable for the HSIM-G09 (long wave length transceiver), connect Launch Mode Conditioning cable as detailed in the following procedure. This procedure is not needed when connecting single mode fiber cable to the HSIM-G09. Do not attach Launch Mode Conditioning cable if the installation is not using an HSIM-G09 with multimode fiber cable.

Launch Mode Conditioning cable is available through Cabletron Systems.

To connect the HSIM-G09 to the network using multimode fiber, perform the following steps:

1.Connect Launch Mode Conditioning cable to the multimode fiber on both ends of the premises cable before connecting the HSIM-G09 to the premises cabling. See Figure 2-5.

Launch Mode

Conditioning

Cable

Installed premises

multimode fiber cable Launch Mode Conditioning

Cable

Long Wavelength

Connect the ends of the

Long Wavelength

Gigabit Fiber Device

premises cabling to the

Gigabit Fiber Device

 

Launch Mode

 

 

Conditioning Cables

 

 

 

mmfLWct

Figure 2-5 Launch Mode Conditioning Cable Connection for the HSIM-G09

2.Once the Launch Mode Conditioning cable is connected to the ends of the premises multimode fiber cable, return to Section 2.3.1 to complete the installation to the HSIM-G09 device.

HSIM-G01/G09 User’s Guide

2-9

Page 22 Page 24
Image 23
Page 22 Page 24
Contents HSIM-G01/G09 User’s Guide Page HSIM-G01/G09 User’s Guide Industry Canada Notice Cabletron Software Program License HSIM-G01/G09 User’s Guide Declaration of Conformity HSIM-G01/G09 User’s Guide Contents Contents Viii HSIM-G01/G09 User’s Guide HSIM-G01 Chapter IntroductionDocument Conventions Using this ManualYour email address Getting HelpRelated Documentation Lanview Diagnostic LEDsOverview ConnectivityUnpacking the HSIM-G Chapter InstallationInstalling an HSIM-G in an Interface Module Installing AN HSIM-GInstalling an HSIM-G Installing the HSIM-G Installing an HSIM-G in a Standalone Device HSIM-G Port Designations Connecting to the NetworkHSIM-G Network Connection Key Latch bottom of SC Connector Keys Bottom view Launch Mode Conditioning Cable Connection for the HSIM-G09 HSIM-G09 Connection Using Multimode CableHSIM-G01/G09 User’s Guide Lanview LEDs ChapterChapter Navigating Local Management Screens Chapter Local ManagementLocal Management Gigabit Ethernet Configuration ScreenGigabit Ethernet Configuration Screen 1 Configuring the HSIM-G Port Setting the Advertised Ability Setting the Operational ModeHSIM-G01/G09 User’s Guide HSIM-G01 Specifications 1000Base-SX Appendix a SpecificationsGigabit Ethernet Specifications Appendix a Specifications HSIM-G09 Specifications 1000Base-LXRegulatory Compliance Physical PropertiesEnvironmental Requirements HSIM-G01/G09 User’s Guide
Top Page Image Contents