Cabletron Systems manual HSIM-G01/G09 User’s Guide

Page 3

Only qualified personnel should perform installation procedures.

NOTICE

Cabletron Systems reserves the right to make changes in specifications and other information contained in this document without prior notice. The reader should in all cases consult Cabletron Systems to determine whether any such changes have been made.

The hardware, firmware, or software described in this manual is subject to change without notice.

IN NO EVENT SHALL CABLETRON SYSTEMS BE LIABLE FOR ANY INCIDENTAL, INDIRECT, SPECIAL, OR CONSEQUENTIAL DAMAGES WHATSOEVER (INCLUDING BUT NOT LIMITED TO LOST PROFITS) ARISING OUT OF OR RELATED TO THIS MANUAL OR THE INFORMATION CONTAINED IN IT, EVEN IF CABLETRON SYSTEMS HAS BEEN ADVISED OF, KNOWN, OR SHOULD HAVE KNOWN, THE POSSIBILITY OF SUCH DAMAGES.

1998 by Cabletron Systems, Inc., P.O. Box 5005, Rochester, NH 03866-5005 All Rights Reserved

Printed in the United States of America

Order Number: 9032398-04 November 1998

Cabletron Systems and LANVIEW are registered trademarks of Cabletron Systems, Inc.

All other product names mentioned in this manual may be trademarks or registered trademarks of their respective companies.

FCC NOTICE

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment uses, generates, and can radiate radio frequency energy and if not installed in accordance with the operator’s manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause interference in which case the user will be required to correct the interference at his own expense.

WARNING: Changes or modifications made to this device which are not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

HSIM-G01/G09 User’s Guide

i

Page 2 Page 4
Image 3
Page 2 Page 4
Contents HSIM-G01/G09 User’s Guide Page HSIM-G01/G09 User’s Guide Industry Canada Notice Cabletron Software Program License HSIM-G01/G09 User’s Guide Declaration of Conformity HSIM-G01/G09 User’s Guide Contents Contents Viii HSIM-G01/G09 User’s Guide HSIM-G01 Chapter IntroductionDocument Conventions Using this ManualYour email address Getting HelpRelated Documentation Lanview Diagnostic LEDsOverview ConnectivityUnpacking the HSIM-G Chapter InstallationInstalling an HSIM-G in an Interface Module Installing AN HSIM-GInstalling an HSIM-G Installing the HSIM-G Installing an HSIM-G in a Standalone Device HSIM-G Port Designations Connecting to the NetworkHSIM-G Network Connection Key Latch bottom of SC Connector Keys Bottom view Launch Mode Conditioning Cable Connection for the HSIM-G09 HSIM-G09 Connection Using Multimode CableHSIM-G01/G09 User’s Guide Lanview LEDs ChapterChapter Navigating Local Management Screens Chapter Local ManagementLocal Management Gigabit Ethernet Configuration ScreenGigabit Ethernet Configuration Screen 1 Configuring the HSIM-G Port Setting the Advertised Ability Setting the Operational ModeHSIM-G01/G09 User’s Guide Appendix a Specifications Gigabit Ethernet SpecificationsHSIM-G01 Specifications 1000Base-SX Appendix a Specifications HSIM-G09 Specifications 1000Base-LXPhysical Properties Environmental RequirementsRegulatory Compliance HSIM-G01/G09 User’s Guide
Top Page Image Contents