Cabletron Systems HSIM-G01 manual Installing an HSIM-G in a Standalone Device

Page 19

Installing an HSIM-G

2.2.2Installing an HSIM-G in a Standalone Device

To install an HSIM-G into a standalone device (e.g., 2E42-27), perform the following steps:

1.Power down the device and remove the power cord.

To install the HSIM-G in a standalone device, the device must first be powered down. Ensure that you remove the power cord and ONLY the screws required to remove the chassis cover.

2.Disconnect any cables connected to the network ports of the device.

Note the ports that have cables attached to them. Write down

TIP the port numbers and label the cables to make it easier to reattach the network properly after the installation.

3.Attach the antistatic wrist strap (refer to the instructions outlined on the antistatic wrist strap package).

4.Remove the standalone device chassis cover (refer to your specific standalone device documentation for instructions on removing the chassis cover).

5.Refer back to Figure 2-1and remove the two faceplate mounting screws and the HSIM coverplate. Save the screws.

6.Remove the four standoff screws. Save the screws.

7.Refer back to Figure 2-2and place the HSIM-G behind the standalone device faceplate.

8.Align the HSIM connector of the HSIM-G with the pins on the standalone device.

9.Press down firmly on the back of the HSIM-G until the pins slide all the way into the HSIM connector.

NOTE

Ensure that the standoffs on the standalone device align with the standoff screw holes on the HSIM-G.

10.Secure the HSIM-G to the module faceplate using the mounting screws saved in step 5.

HSIM-G01/G09 User’s Guide

2-5

Page 18 Page 20
Image 19
Page 18 Page 20
Contents HSIM-G01/G09 User’s Guide Page HSIM-G01/G09 User’s Guide Industry Canada Notice Cabletron Software Program License HSIM-G01/G09 User’s Guide Declaration of Conformity HSIM-G01/G09 User’s Guide Contents Contents Viii HSIM-G01/G09 User’s Guide HSIM-G01 Chapter IntroductionDocument Conventions Using this ManualYour email address Getting HelpRelated Documentation Lanview Diagnostic LEDsOverview ConnectivityUnpacking the HSIM-G Chapter InstallationInstalling an HSIM-G in an Interface Module Installing AN HSIM-GInstalling an HSIM-G Installing the HSIM-G Installing an HSIM-G in a Standalone Device HSIM-G Port Designations Connecting to the NetworkHSIM-G Network Connection Key Latch bottom of SC Connector Keys Bottom view Launch Mode Conditioning Cable Connection for the HSIM-G09 HSIM-G09 Connection Using Multimode CableHSIM-G01/G09 User’s Guide Lanview LEDs ChapterChapter Navigating Local Management Screens Chapter Local ManagementLocal Management Gigabit Ethernet Configuration ScreenGigabit Ethernet Configuration Screen 1 Configuring the HSIM-G Port Setting the Advertised Ability Setting the Operational ModeHSIM-G01/G09 User’s Guide Gigabit Ethernet Specifications Appendix a SpecificationsHSIM-G01 Specifications 1000Base-SX Appendix a Specifications HSIM-G09 Specifications 1000Base-LXEnvironmental Requirements Physical PropertiesRegulatory Compliance HSIM-G01/G09 User’s Guide
Top Page Image Contents