Cabletron Systems HSIM-G01 manual Key Latch bottom of SC Connector Keys Bottom view

Page 22

Chapter 2: Installation

SX

HSIM-G

LNK

Key Latch (bottom of SC Connector)

SC Connector

keys

SC Connector

(bottom view)

Figure 2-4 Fiber Connections

3.At the other end of the fiber optic cable, attach the SC connector to the other device.

4.Verify that a link exists by checking that the link (LNK) LED is ON (solid green), the port receive (RX) LED is ON (flashing amber, blinking green, or solid green). Refer to Chapter 3 for the layout of the LEDs. If the RX LED is OFF and the transmit (TX) LED is not blinking amber, perform the following steps until it is ON:

a.Check that the power is turned on for the device at the other end of the link.

b.Verify proper crossover of fiber strands between the port on the HSIM-G and the fiber optic device at the other end of the fiber optic link segment.

c.Verify that the fiber connection meets the dB loss specifications outlined in Appendix A.

2-8	HSIM-G01/G09 User’s Guide

Image 22

Contents HSIM-G01/G09 User’s Guide Page HSIM-G01/G09 User’s Guide Industry Canada Notice Cabletron Software Program License HSIM-G01/G09 User’s Guide Declaration of Conformity HSIM-G01/G09 User’s Guide Contents Contents Viii HSIM-G01/G09 User’s Guide Chapter Introduction HSIM-G01Using this Manual Document ConventionsGetting Help Your email addressConnectivity Lanview Diagnostic LEDsOverview Related DocumentationChapter Installation Unpacking the HSIM-GInstalling AN HSIM-G Installing an HSIM-G in an Interface ModuleInstalling an HSIM-G Installing the HSIM-G Installing an HSIM-G in a Standalone Device Connecting to the Network HSIM-G Port DesignationsHSIM-G Network Connection Key Latch bottom of SC Connector Keys Bottom view HSIM-G09 Connection Using Multimode Cable Launch Mode Conditioning Cable Connection for the HSIM-G09HSIM-G01/G09 User’s Guide Chapter Lanview LEDsChapter Chapter Local Management Navigating Local Management ScreensGigabit Ethernet Configuration Screen Local ManagementGigabit Ethernet Conﬁguration Screen 1 Conﬁguring the HSIM-G Port Setting the Operational Mode Setting the Advertised AbilityHSIM-G01/G09 User’s Guide Gigabit Ethernet Specifications Appendix a SpecificationsHSIM-G01 Speciﬁcations 1000Base-SX HSIM-G09 Speciﬁcations 1000Base-LX Appendix a SpeciﬁcationsEnvironmental Requirements Physical PropertiesRegulatory Compliance HSIM-G01/G09 User’s Guide