Chapter 2: Installation
2.2INSTALLING FAST ETHERNET (PORT) INTERFACE MODULES
Only qualified personnel should perform installation procedures.
Fast Ethernet (Port) Interface Modules (FEPIMs) must be installed in the HSIM-FE6 before installing the HSIM-FE6 in the host device. The FEPIMs provide connectivity to the network. At least one FEPIM must be installed in either port one or port two. To install an FEPIM in the HSIM-FE6, proceed as follows:
The FEPIM and the HSIM-FE6 are sensitive to static discharges. Use an antistatic wrist strap and observe all static precautions during this procedure. Failure to do so could damage the FEPIM or the HSIM-FE6.
The FE-100F3 uses Class 1 lasers. Do not use optical instruments to view the laser output. The use of optical instruments to view laser output increases eye hazard. When viewing the output optical port, power must be removed from the network adapter.
1.Remove the coverplate from the port slot where the FEPIM will be installed.
To remove the coverplate, refer to Figure 2-1and proceed as follows:
a.Remove the two screws fastening the coverplate to the standoffs. Save the screws.
b.Lift and remove the coverplate from the top of the front standoffs.