Cabletron Systems manual Installing the BRIM-F6

Installing the BRIM-F6

FPIM Screws

FPIM Connector

Standoffs

		-F6		STS
BRIM -			F6
	BRIMRCV			STS
	XMT	RCV
PWR	XMT
PWR				LNK
		TWR		LNK
	WRP TWR
LNK	WRP
LNK

B

B

FPIM

A

FPIM

Figure 2-2. Installing FPIMs

2.3Installing the BRIM-F6

This section contains procedures on how to install a BRIM-F6 to upgrade or change the capabilities of a device’s motherboard.

Note: Cabletron provides disposable wrist straps and faceplate and standoff screws in both the BRIM package and on devices that support BRIM technology.

You can install a BRIM-F6 in any device that supports BRIM technology (e.g., EMM-E6, ESXMIM, NBR-420/620, or MicroMMAC). The following subsections provide instructions for installing a BRIM-F6 in a MIM or in a stand-alone hub. Refer to specific MIM or hub documentation for exact BRIM slot and connector locations.

BRIM-F6 User’s Guide Page 2-3