Cabletron Systems BRIM-F6 manual Chapter Installation, Unpacking the Brim and the FPIMs

CHAPTER 2

INSTALLATION

This chapter contains instructions for unpacking the BRIM-F6, installing FPIMs, and installing the BRIM-F6 into Cabletron devices that support BRIM technology.

Note: The BRIM-F6 is not shipped with the FPIMs installed. You must order the correct FDDI Port Interface Modules based upon your network requirements.

To install the BRIM and FPIMs, you need the following tools:

•1 disposable wrist strap (provided with any BRIM, MIM or hub)

•1 Phillips screwdriver.

Caution: Observe all static precautions while handling modules.

2.1Unpacking the BRIM and the FPIMs

Unpack the modules as follows:

1.Remove the shipping box material covering the module.

2.Carefully remove the module from the shipping box. Leave the module in its static-shielding bag until you are ready to install.

3.After removing the module from its static-shielding bag, visually inspect the device. If you notice any signs of damage, contact Cabletron Systems Technical Support immediately.

BRIM-F6 User’s Guide Page 2-1