Cabletron Systems ELS100-8TXUF2 manual Installation, Inspecting Your Shipment, Site Requirements

Page 23

2. INSTALLATION

Inspecting Your Shipment

When you receive the shipment of your switch, check the package contents and make sure you have the following items:

•ELS100-8TXUF2 Fast Ethernet switch

•Mounting velcro

•Rubber feet

•Power adapter

•This document

Site Requirements

Before you install the switch, make sure the site meets the following requirements:

•Mounting

Provide a flat table, wall or shelf surface.

•Power source

Provide a power source within six feet (1.8 m) of the installation loca- tion. This source must provide 100 VAC to 240 VAC, and 50 Hz to 60 Hz power, with a 100 VA minimum. Power specifications for the switch are shown in Appendix A, “Technical Specifications.”

•Environmental

Install the ELS100-8TXUF2 switch in a dry area, with adequate air circulation. Avoid placing the switch in direct sunlight or near other heat sources, such as hot-air vents. For temperature and humidity specifications, see Appendix A, “Technical Specifications.”

•Ventilation

Do not restrict airflow by covering or obstructing air inlets on the side of the switch.

9033029

Installation 7

Image 23

Contents Installation User Guide ELS100-8TXUF2 Fast Ethernet SwitchPage FCC Notice Industry Canada Notice Cabletron SYSTEMS, INC Program License Agreement 9033029 9033029 9033029 Cabletron Systems Limited Program License Agreement Viii 9033029 Declaration of Conformity 9033029 Table of Contents ELS100-8TXUF2 Conventions PrefacePurpose AudienceXiv Preface Description FeaturesProduct Overview Name Function Front PanelPort LEDs Defined Rear PanelAuto-negotiation Feature SummariesIeee 802.1D Bridge Frame Buffering and Frame LatencyFlow Control Full Duplex ModeApplication Examples LEDsClient/Server Network Application Client/Server Network ApplicationSite Requirements InstallationInspecting Your Shipment Mounting the Switch on a Table or Shelf Mounting the Switch on a Wall Mounting the Switch on a WallPower-Up Verification Powering the SwitchFiber Network Cable RequirementsCopper 10Base-T/100Base-TX Ports Inserting an RJ-45 Connector into a Port100Base-FX Fiber Ports Inserting a Dual SC Connector into a PortELS100-8TXUF2 General Appendix A. Technical SpecificationsMemory Port SpecificationsMDI/MDI-X Crossover Cable Wiring PhysicalTable A-2. Power Adapter Requirements Power Adapter RequirementsELS100-8TXUF2 Appendix B. Flow Control ELS100-8TXUF2 Term Definition Appendix C.ACRONYMS AbbreviationsELS100-8TXFU2 Index ELS100-8TXUF2