Cabletron Systems ELS100-8TXUF2 manual FCC Notice

Page 3

Notice

Only qualified personnel should perform installation procedures.

NOTICE

Cabletron Systems reserves the right to make changes in specifications and other information contained in this document without prior notice. The reader should in all cases consult Cabletron Systems to determine whether any such changes have been made.

The hardware, firmware, or software described in this manual is subject to change without notice.

IN NO EVENT SHALL CABLETRON SYSTEMS BE LIABLE FOR ANY INCIDENTAL, INDIRECT, SPECIAL, OR CONSEQUENTIAL DAMAGES WHATSOEVER (INCLUDING BUT NOT LIMITED TO LOST PROFITS) ARISING OUT OF OR RELATED TO THIS MANUAL OR THE INFORMATION CONTAINED IN IT, EVEN IF CABLETRON SYSTEMS HAS BEEN ADVISED OF, KNOWN, OR SHOULD HAVE KNOWN, THE POSSIBILITY OF SUCH DAMAGES.

©1999 by Cabletron Systems, Inc., P.O. Box 5005, Rochester, NH 03866-5005 All Rights Reserved

Printed in Taiwan, R.O.C.

Order Number: 9033029 April 1999

Cabletron Systems, is a registered trademark and SmartSwitch is a trademark of Cabletron Systems, Inc.

All other product names mentioned in this manual may be trademarks or registered trademarks of their respective companies.

FCC NOTICE

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment uses, generates, and can radiate radio frequency energy and if not installed in accordance with the operator’s manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause interference in which case the user will be required to correct the interference at his own expense.

WARNING: Changes or modifications made to this device which are not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

9033029

i

Page 2 Page 4
Image 3
Page 2 Page 4
Contents Installation User Guide ELS100-8TXUF2 Fast Ethernet SwitchPage FCC Notice Industry Canada Notice Cabletron SYSTEMS, INC Program License Agreement 9033029 9033029 9033029 Cabletron Systems Limited Program License Agreement Viii 9033029 Declaration of Conformity 9033029 Table of Contents ELS100-8TXUF2 Conventions PrefacePurpose AudienceXiv Preface Features Product OverviewDescription Name Function Front PanelPort LEDs Defined Rear PanelAuto-negotiation Feature SummariesIeee 802.1D Bridge Frame Buffering and Frame LatencyFlow Control Full Duplex ModeApplication Examples LEDsClient/Server Network Application Client/Server Network ApplicationInstallation Inspecting Your ShipmentSite Requirements Mounting the Switch on a Table or Shelf Mounting the Switch on a Wall Mounting the Switch on a WallPower-Up Verification Powering the SwitchNetwork Cable Requirements CopperFiber 10Base-T/100Base-TX Ports Inserting an RJ-45 Connector into a Port100Base-FX Fiber Ports Inserting a Dual SC Connector into a PortELS100-8TXUF2 General Appendix A. Technical SpecificationsMemory Port SpecificationsMDI/MDI-X Crossover Cable Wiring PhysicalTable A-2. Power Adapter Requirements Power Adapter RequirementsELS100-8TXUF2 Appendix B. Flow Control ELS100-8TXUF2 Term Definition Appendix C.ACRONYMS AbbreviationsELS100-8TXFU2 Index ELS100-8TXUF2
Top Page Image Contents