Cabletron Systems 7C04 Workgroup manual Notch

Page 17

Installation

3.Align the notch on the top of the power supply module with the semi-circular tab in the top center of the power supply module cavity of the chassis.

notch

MAC ADR	SN
	1
	2	POWER IN
	SN	POWER OUT
	SN	OVERLOAD
	SN	FANS
	3
	SN
	4

Figure 2-3. Installing the power supply module into a 7C04 Chassis

4.Slide the power supply module into the chassis until the power supply module connects to the chassis’ backplane and the module’s front panel is ﬂush with the front of the chassis.

Warning: Do not force the power supply module into place. If you encounter significant resistance before the front panel is flush with the front of the chassis, remove the power supply module and reinsert.

5.Tighten (turn clockwise) the knurled knob on the power supply module’s front panel.

2-6

Image 17

Contents 7C04 Workgroup SmartSWITCH Chassis User’s Guide Page FCC Notice Vcci Notice Contents Chapter Introduction Using this ManualUsing the Smartswitch Manual SET Chassis Overview C04 Workgroup SmartSwitch ChassisSmartSwitch interface modules 1 7X00 SmartSwitch Controller ModuleOperations Traditional SwitchSecureFast Packet Switch Site Guidelines Getting Help Related ManualsUnpacking the 7C04 Chassis Chapter InstallationAttaching Mounting Brackets Installing the 7C04 Chassis in AN Equipment RackAttaching the Right Mounting Bracket to the 7C04 Chassis A 7C04 Chassis mounted in an equipment rack Mounting the 7C04 ChassisInstalling the Power Supply Module 7C04 Chassis Power Supply ModuleUnpacking the Power Supply Module Notch Powering up the Power Supply Module Power Supply Module Removing the Power Supply ModuleChapter Troubleshooting LEDsWork Group SmartSwitchLED Color Indicates Action Overload LED Safety Chapter Technical SpecificationsEMI ImmunityPower ServiceDimensions WeightEnvironmental