Chapter Installation | Cabletron Systems 7C04 Workgroup specification

CHAPTER 2 INSTALLATION

The 7C04 Chassis can be used as a stand-alone chassis or rack mounted in a standard 19-inch equipment rack provided there is sufﬁcient space surrounding the chassis for cooling. This chapter provides detailed information for unpacking and setting up the chassis, as well as installing and removing the chassis’ power supply module. You will not need any special tools or equipment; however, the Site Guidelines detailed in Chapter 1 must be followed.

2.1 UNPACKING THE 7C04 CHASSIS

Unpack the 7C04 Chassis by using the following steps:

1.Carefully remove the chassis from the shipping box. (Save the shipping box and packing materials in the event the chassis must be reshipped.)

2.Slide the two foam end caps off the chassis, and remove the plastic bag. Set the chassis aside.

3.Remove the accessory package and verify that it contains two mounting brackets.

4.Examine the chassis (and brackets) and check for damage. If damage exists, contact Cabletron Systems Technical Support.

2-1