Cabletron Systems 9000 manual Tools Needed, Unpacking the Module

Page 15

Chapter 2

Installation

This chapter describes the physical layout of the 9G421-02/9G429-02 module and explains preparation and installation procedures for use in a SmartSwitch 9000 chassis. The 9G421-02/9G429-02 occupies a single slot in the SmartSwitch 9000 chassis. Install the 9G421-02/9G429-02 by following the steps in Unpacking the Module below.

Only qualiÞed personnel should perform installation procedures.

!Never expose the moduleÕs components to Electrostatic Discharge. Make sure you

CAUTION

have attached the moduleÕs disposable grounding strap to your wrist and always place the module on a non-conductive surface.

Tools Needed

¥Phillips screwdriver

NOTE

The INB Terminator modules must be installed on the rear of the chassis before powering up this module. Refer to the INB Terminator Modules Installation Guide for the installation procedure. The INB Terminator modules are essential to the proper operation of the bus on the chassis.

Unpacking the Module

1.Carefully remove the module from the shipping box. (Save the box and packing materials in the event it must be reshipped.)

2.Remove the module from the plastic bag. Observe all precautions to prevent damage from Electrostatic Discharge (ESD).

3.Carefully examine the module, checking for damage. If any damage exists, DO NOT install the module. Contact Cabletron Systems immediately.

2-1

Page 14 Page 16
Image 15
Page 14 Page 16
Contents 9032344-02 Page Page FCC Notice Industry Canada NoticeVcci Notice Class 1 Laser Transceivers Safety InformationDeclaration of Conformity Addendum Contents CPU Chapter Lanview LEDs Appendix a SpecificationsIntroduction Introduction Features Related Manuals Your email address Getting HelpIntroduction Unpacking the Module Tools Needed9G421-02/9G429-02 Circuit Boards Physical LayoutDIP Switch User Accessible Daughterboard ComponentsSwitch Function Description Daughterboard Attached to the 9G421-02/9G429-02 Removing the Daughterboard from the MotherboardSMB-1 Prom Boot Prom Daughterboard Components Installing the Module into the SmartSwitch 9000 Chassis Installing the 9G421-02/9G429-02 Module Reset Switch Reset SwitchOperation SMB-10 Bus System Diagnostic ControllerSystem Management Buses SMB-1 BusSecureFast SmartSwitch Architecture DC/DC ConverterINB Interface I960 Core Lanview LEDs 2lists the states of the INB Receive LED 4lists the states of the Port Receive LED Lanview LEDs Technical Specifications MemoryNetwork Interfaces Regulatory Compliance ServiceEnvironment DimensionsWeight PhysicalSpecifications
Related manuals
Manual 26 pages 46.69 Kb Manual 14 pages 9.57 Kb
Top Page Image Contents