Cabletron Systems 9000 manual System Management Buses, System Diagnostic Controller, SMB-1 Bus

Page 26

Operation

System Management Buses

There are two management channels within the SmartSwitch 9000 system: the SMB-1 and the SMB-10. These buses provide side-band management and inter- module management communication.

SMB-1 Bus

The SMB-1 is a 1 Mbps management bus located within the SmartSwitch 9000. This bus is utilized by all diagnostic controllers in the system, including connectivity modules, power supply modules and the environmental module. The SMB-1 transports inter-chassis information between system components, such as power and environmental information, as well as diagnostic messages. Periodic loop-back tests are performed by all modules that share this bus to ensure the validity of SMB-1. In the event a failure is detected on SMB-1, the SMB-10 may be used as an alternate communication channel.

SMB-10 Bus

The SMB-10 is a 10 Mbps management bus located within the SmartSwitch 9000. This bus is used for inter-chassis communication of modules as well as serving as a side-band management channel into the SmartSwitch 9000. The SMB-10 is externalized from the chassis via an optional Ethernet Port Interface Module (EPIM) located on the front of the Environmental Module. Through an EPIM connection, full-SNMP management of the SmartSwitch 9000 is available out-of- band from user data. Modules that share the SMB-10 bus periodically send out loop-back packets to ensure the validity of SMB-10. If a fault is detected on the SMB-10, the SMB-1 can be used as an alternate communication channel by the modules.

System Diagnostic Controller

This diagnostic controller is composed of a Z-80 microprocessor and its supporting logic. The diagnostic controller is designed to control the power-up sequencing of modules, monitor the 9G421-02/9G429-02 input and output power parameters, keep watch over the main host processor, monitor the temperature, and control the SMB LANVIEW diagnostic LEDs. Although the system diagnostic controller and the main host processor can operate independently of each other if needed, they exchange status information and overall module condition. The information gathered by the diagnostic controller is available to the network manager via local/remote management and the LCD located on the environment module. The 9G421-02/9G429-02 is designed to continue functioning in the event of a diagnostic controller fault.

3-2

Image 26
Contents 9032344-02 Page Page Vcci Notice FCC NoticeIndustry Canada Notice Safety Information Class 1 Laser TransceiversDeclaration of Conformity Addendum Contents Chapter Lanview LEDs Appendix a Specifications CPUIntroduction Introduction Features Related Manuals Getting Help Your email addressIntroduction Tools Needed Unpacking the ModulePhysical Layout 9G421-02/9G429-02 Circuit BoardsUser Accessible Daughterboard Components DIP SwitchSwitch Function Description Removing the Daughterboard from the Motherboard Daughterboard Attached to the 9G421-02/9G429-02SMB-1 Prom Boot Prom Daughterboard Components Installing the Module into the SmartSwitch 9000 Chassis Installing the 9G421-02/9G429-02 Module Reset Switch Reset SwitchOperation SMB-1 Bus System Diagnostic ControllerSystem Management Buses SMB-10 BusINB Interface SecureFast SmartSwitch ArchitectureDC/DC Converter I960 Core Lanview LEDs 2lists the states of the INB Receive LED 4lists the states of the Port Receive LED Lanview LEDs Network Interfaces Technical SpecificationsMemory Service Regulatory CompliancePhysical DimensionsWeight EnvironmentSpecifications
Related manuals
Manual 26 pages 46.69 Kb Manual 14 pages 9.57 Kb