Cabletron Systems 9000 manual Reset Switch

Page 24

Installation

The Reset Switch

The Reset switch is located under the top plastic tab, as shown in Figure 2-6.Use the reset switch to reset the moduleÕs processor, shutdown (power down) the module, and/or restart the module.

¥To reset the moduleÕs i960 processor, press the reset switch twice within three seconds.

¥To shut down the module, press and hold the reset switch for three or more seconds.

¥To restart the module, press the reset switch momentarily.

SNMP management may be used to disable this switch to enhance module security.

Reset Switch

SMB CPU

Figure 2-6. The Reset Switch

2-10

Image 24
Contents 9032344-02 Page Page FCC Notice Industry Canada NoticeVcci Notice Safety Information Class 1 Laser TransceiversDeclaration of Conformity Addendum Contents Chapter Lanview LEDs Appendix a Specifications CPUIntroduction Introduction Features Related Manuals Getting Help Your email addressIntroduction Tools Needed Unpacking the ModulePhysical Layout 9G421-02/9G429-02 Circuit BoardsUser Accessible Daughterboard Components DIP SwitchSwitch Function Description Removing the Daughterboard from the Motherboard Daughterboard Attached to the 9G421-02/9G429-02SMB-1 Prom Boot Prom Daughterboard Components Installing the Module into the SmartSwitch 9000 Chassis Installing the 9G421-02/9G429-02 Module Reset Switch Reset SwitchOperation System Diagnostic Controller System Management BusesSMB-1 Bus SMB-10 BusSecureFast SmartSwitch Architecture DC/DC ConverterINB Interface I960 Core Lanview LEDs 2lists the states of the INB Receive LED 4lists the states of the Port Receive LED Lanview LEDs Technical Specifications MemoryNetwork Interfaces Service Regulatory ComplianceDimensions WeightPhysical EnvironmentSpecifications
Related manuals
Manual 26 pages 46.69 Kb Manual 14 pages 9.57 Kb