Brocade Communications Systems 8000, 6505, 6520 Supported switches, Configuring Internet Explorer

Page 13

Supported switches

1

Configuring Internet Explorer

Correct operation of EZSwitchSetup Switch Manager with Internet Explorer requires specifying the appropriate settings for browser refresh frequency and process model. Browser pages should be refreshed frequently to ensure the correct operation of Switch Manager.

1.Select Tools > Internet Options.

2.Select the General tab.

3.Click the Settings button under “Browsing history.”

4.Click Every time I visit the webpage under “Check for newer versions of stored pages,” as shown in Figure 2.

5.Click OK to save the changes.

FIGURE 2 Configuring Internet Explorer

Supported switches

You can use EZSwitchSetup with the switches listed in “Supported hardware and software” on page v.

Your switch must meet the following requirements:

It must be connected to an Ethernet LAN that is accessible by the host. If it is not, the system issues the message “Page not Found.”

It must have licensed FC ports. If the switch has no licensed FC ports, you must first install a POD license and then enable the affected ports. For more information, refer to “Adding a port license” on page 38

EZSwitchSetup Administrator’s Guide

3

53-1002744-01

 

Image 13
Contents EZSwitchSetup Brocade Communications Systems, Incorporated Contents Appendix a EZSwitchSetup Limitations How this document is organized This chapterSupported hardware and software Document conventions What’s new in this documentText formatting Corporation Referenced Trademarks and Products Key termsGetting technical help Additional informationBrocade resources Other industry resourcesFT00X0054E9 Document FeedbackEZSwitchSetup Administrator’s Guide Overview of EZSwitchSetup Introducing EZSwitchSetupOperating system Browser JRE version EZSwitchSetup software and hardware requirementsConfiguring Internet Explorer Supported switchesLanguage support for EZSwitchSetup EZSwitchSetup Administrator’s Guide 53-1002744-01 Language support for EZSwitchSetup Installing and running the EZSwitchSetup wizard Setting Up Your SwitchLaunching the EZSwitchSetup wizard EZSwitchSetup introduction window Connecting cablesConnect Cables window Ethernet version, without serial cable Ioioi First Discover Switch window Discovering the switchKeep the current switch IP configuration Confirming IP addresses Installing and running the EZSwitchSetup wizard Click Continue Switch discovery failure Configuring the switchEZSwitchSetup Setup Parameters window Setting switch parametersZoning selection options Specifying devices Configuring zones on the switchSpecify Devices window Connecting devices and completing the setupEZSwitchSetup Administrator’s Guide Ioioi Oioi Connecting devices and completing the setup Connecting devices and completing the setup Switch Manager overview Managing Your SwitchTask panel EZSwitchSetup Switch Manager componentsContent Switch ViewStatus bar Launching the EZSwitchSetup Switch ManagerLogging Switch Manager sessionsLogging out Viewing switch information Viewing fan, temperature, and power supply status Viewing the status indicator legendPort status Port State LEDs Port Information tab Switch Information tabChanging switch information Managing devices Adding a port licenseEZSwitchSetup Administrator’s Guide 53-1002744-01 Detailed Device information Device connectionsDisplay Connections window Assigning and renaming device aliasesDevice aliases moved under Current Aliases Zoning management Device alias in Zone Access MapZone Access Map Viewing the zone access mapEdit HBA/Storage Accessibility Matrix is displayed Editing the zoning configurationZoning management Restoring Typical Zoning Validating zoning configurationMaking EZSwitchSetup your default switch manager Accessing Web Tools for advanced managementGeneral limitations This appendixGeneral limitations Index EZSwitchSetup Administrator’s Guide EZSwitchSetup Administrator’s Guide 53-1002744-01 EZSwitchSetup Administrator’s Guide
Related manuals
Manual 8 pages 22.19 Kb