Extron electronic manual Installation, cont’d, Connecting the MVP 104GX

Installation, cont’d

13Genlock input — Connect an external black burst signal for genlocking the video signal in broadcast or other sync-critical applications.

14Genlock output — Connect any downstream equipment that requires genlocking for broadcast or other sync-critical applications.

Connecting the MVP 104GX

The MVP 104GX can be connected to as many as four input devices simultaneously and output to as many as three devices simultaneously. Follow the steps below and see the installation example in figure 2-3.

INPUTS

100-240 V 0.3A

	MAC
50/60 Hz	VGA

I
N	PAL OUT	75 OHM
P
U
T
S

	VIDEO				GENLOCK
O		R/R-Y	G/Y	B/B-Y	IN
U
T
P	S-VIDEO	S-VIDEO
U
T		RGB
S		H	V	S	OUT
		R-Y/B-Y/Y				RS-232

	VSC 150		VCR
	Document		Video
PC Computer	Camera
			Camera
			GENLOCK
INPUT 1	INPUT 2INPUT 3 INPUT 4	OUTPUT	IN	OUT

IN	IN		A
	IN	IN
OUT	OUT
	OUT	OUT	B	C

100-240V 50/60 Hz 0.5A

Rear

INPUTS	OUTPUT RS-232/RS-422
L 1 R L 2 R L 3 R L 4 R	L 1 R

REMOTE

VCR	Plasma Display	Videoconferencing	RS-232
	OUTPUTS	System	Control

Figure 2-3 — MVP 104GX installation example

1

2

3

If the MVP 104GX is to be rack mounted, see the earlier Rack Mounting Procedure.

Turn off power to the MVP 104GX and all other devices that will be connected.

Using Inputs 1, 2, 3, and 4, attach up to four composite/S-video input devices to the MVP 104GX. Inputs 1 and 2 can be either composite video or S-video, inputs 3 and 4 are composite video only. The buffered loopout connectors for all inputs can be used to output the identical signal to other devices.

Any inputs must be either all NTSC or all PAL, they cannot be both.

2-4 MVP 104GX Installation