Extron electronic manual Quick Start MVP 104GX, Rack mounting, Connecting the MVP 104GX

Quick Start — MVP 104GX

Installation

Step 1

Turn off power to the MVP 104GX and all other devices that will be connected.

Step 2

If the MVP 104GX is to be rack mounted, insert the mounting screws and washers, as shown on the right.

Step 3

Using Inputs 1, 2, 3, and 4, attach up to four composite/S-video input devices to the MVP 104GX. Inputs 1 and 2 can be either composite video or S-video, inputs 3 and 4 are composite video only.

Rack mounting

1INPUT S

2

3

4

FREEZE

AUDIO	PRESETS
1
2
3
4
	ST	ORE
			ACT
			IVE	AD
	PFAC		1		JUST
	TTOERNYS		3		MENTS
	AT	R	2
			4
					MENU
					NEXT

AD	JUST
	MULTI	VI	M	VP	10
		DEO				4GX
				PRO
					CESSOR

INPUT 1	INPUT 2	INPUT 3	INPUT 4	OUTPUT
IN	IN	IN	IN	A
					INPUTS	OUTPUT RS-232/RS-422
OUT	OUT				L 1 R L 2 R L 3 R L 4 R	L 1 R
		OUT	OUT	B	C
						REMOTE

Any inputs must be either all NTSC or

all PAL, they cannot be both.

The buffered loopout connectors for all inputs can be used to output the identical signal to other devices. See the application connection diagram on the right.

Step 4

Connect up to three output devices to the MVP 104GX using composite video output A, composite video output B, and S-video output C.

Step 5

For stereo audio input, connect up to four audio sources to audio inputs 1, 2, 3, and 4. See the Audio input and output section in chapter 2 for illustrations and warnings.

Step 6

For stereo audio output, connect an audio output device to the 3.5 mm stereo audio output connector. See the Audio input and output section in chapter 2 for illustrations and warnings.

Step 7

If the MVP 104GX is to be connected to a computer or host controller for remote control, connect the host’s RS-232/RS-422 cable to the

9-pin female RS-232/RS-422 remote connector of the MVP 104GX. For an RS-232/RS-422 pinout table, see the Remote Control Port (RS-232/RS-422)section in chapter 5.

Connecting the MVP 104GX

Extron	PC Computer
VSC 150
Scan	External	RS-232 Control
Converter	Genlock
	Timing

Videoconferencing System

MVP 104GX

Plasma Display

Document Camera VCR Video Camera VCR

If a genlock device is to be connected to the MVP 104GX, see Setting Up Genlock and Vertical Interval Switching in chapter 2.

The MVP 104GX comes from the factory already configured for RS-232. To set the MVP 104GX for RS-422 operation, refer to “Configuring the MVP 104GX for RS- 422” in the appendix.

Step 8

Power up the input and output devices, then connect power to the MVP 104GX. A summary of the menu system is described on the following page. See the appropriate chapters in this manual for further details.