The FPM 101 Power Meter offers:
•When used with a compatible light source such as the FLS 101, WAVE ID enables the power meter to automatically detect and set wavelengths, simplifying setup.
•Power measurements in dBm or μW; insertion loss in dB.
•270 Hz, 330 Hz, 1 kHz, 2 kHz tone detection.
The FLS 101 Light Source offers:
•Integrated LED and laser light source.
•WAVE ID allows a compatible power meter to automatically identify and measure a wavelength.
•Dual WAVE ID allows a compatible power meter to automatically identify and measure two wavelengths.
•CW mode for use with power meters without WAVE ID.
•2 kHz tone for use in fiber tracing or locating.
•50 µm and 62.5 µm mandrels included for different diameter fiber cable.
•National Institute of Standards and Technology (NIST) traceable.
| Optical Power Meter |
| |
| 0000 | Hz | |
| nm | ||
| 0.00 | ∝W | |
| dB | ||
WAVE ID | nm | ||
0000 | |||
|
| Hz | |
| 0.00 | ∝W | |
| dB | ||
|
| ||
µW | Set |
| |
dB | Ref | λ | |
dBm | |||
|
|
FPM 101
FIBER POWER METER
| 9V |
850nm 1300nm | 1310nm 1550nm |
| FLS 101 |
| FIBER LIGHT SOURCE |
CW | CW |
850nm | 1310nm |
1300nm | 1550nm |
| Tone |
Figure 1. FPM 101 Power Meter and FLS 101 Laser Source
Power Source
The units each operate on two AA alkaline or rechargeable batteries each.
NOTE: If the battery level becomes too low, each unit turns itself off.
Fiber Optic Test Meters • Introduction | 2 |