Extron electronic SFI244 Series Installation and Operation, Installation Overview, Rack mounting

Installation and Operation

Installation Overview

To install and set up the IPL T SF24 and SFI244 interfaces, follow these steps:

1Turn all of the equipment off. Make sure that the video sources (DSS, cable boxes, or other devices), the IPL interface, the output devices (monitors, VCRs, projectors, etc.) and the serial controller are all turned off and disconnected from the power source.

2Mount the IPL T unit. See Mounting the IPL T interface below.

3Attach the cables. See Connecting the Hardware in chapter 3.

4Connect power cords and turn on the devices in the following order: output devices (projectors, monitors, speakers), the IPL T unit, a serial controller or computer (PC), then all input devices (DSS, cable boxes, etc.).

5Configure the IPL T interface through Telnet, then access the IPL T interface using an Internet browser.

Mounting the IPL T Interface

Rack mounting

For optional rack mounting, mount the interface on a VersaTools 19" 1U Rack Shelf (Extron part #60-190-20)

(figure 2-1) or a standard Universal 1U Rack Shelf (Extron part #60-190-01) (figure 2-2). On the standard rack shelf, the interface mounts in one of four locations to the rear of the rack or in one of four locations to the front of the rack.

1.	If feet were previously installed on the bottom of the IPL T
	unit, remove them.
2.	Mount the interface on the rack shelf, using two 4-40 x
	3/16” screws in opposite (diagonal) corners to secure the
	interface to the shelf.
3.	Install blank panel(s) or other unit(s) to the rack shelf.
4.	Insert the shelf into the rack, aligning the holes in the shelf
	with those in the rack.
5.	Secure the shelf to the rack using the supplied machine
	screws. This shelf can be mounted in the front or in the
	rear of the rack.

1U Rack Shelf

1/4 Rack Width False Front

Face Plate

Use 2 mounting holes on

opposite corners.

(2) 4-40 x 3/16" Screws

Figure 2-1 — Rack mounting the interface on the VersaTools shelf (SFI244 model shown)

Only products in the IPTools™ or VersaTools lines can be mounted to a VersaTools shelf. Any 1U rack-mountable Extron product can be mounted on the standard shelf (Extron part #60-190-01).

IPLT

SFI244

IPLT

SFI244

MDA SERIES

Figure 2-2 — Mounting the interface on the standard shelf

2-2 IPL T SF24 and IPL T SFI244 • Installation and Operation IPL T SF24 and IPL T SFI244 • Installation and Operation 2-3