Extron electronic ISS 506 manual Configuring a logo, Level

Configuring a logo

Once a bitmap is captured or uploaded via the LAN port, you can assign it to one of the two logo locations. After it is assigned, you can position it and remove (key out) unwanted portions of the image (such as backgrounds).

Assign the bitmap to a logo and configure the logo as follows:

1. Press and hold the Next button (figure 3-26). While holding Next, press and release the Logo 1/Black or Logo 2/Black button (the logo to which you want to assign a bitmap). Release the Next button.

Default

Cycle

Press and hold Next
Press and release Logo.		/BLACK	NEXT
		LOGO 1
Release Next.				30 sec.
	Step
					Press
1
						NEXT
	Logo #1 Select
						Step
	9.BMP

3

30 sec.

Logo #1 Pre Pos

X=0001 Y=0001

Press
	NEXT	30 sec.
		Logo #1 Pre Type
	Step	<Level>	RGB

5

Press

NEXT

To

Step Figure 3-27

7

Rotate the knobs to select

the bitmap image to

assign to this logo button.

Step

2

		0000	0000
		through	through
	upper H size		upper V size
Step		Rotate the knobs to
		move the upper-left
4
		corner of the logo into

the desired position.

Rotate the knobs to select the method — luminance or color (RGB) — of keying out the backround.

Step

6

		Starting point
		of logo
Figure 3-26 — Configuring a logo
2.	Rotate the Adjust { knob to display, one at a time, all of the bitmap images
	available for selection and the Black Screen selection.
3.	Press the Next button. The Logo Position submenu appears.

NDepending on the size of the bitmap image, the Logo Position submenu may take a few seconds to appear.

NIf you selected Black Screen in step 3, the PIP skips the Logo Position submenu and proceeds straight to the Logo Type screen (step 6).

4. Use the Adjust knobs to shift the starting point (upper-left corner) of the logo.

NRotate the Adjust [ knob to shift the starting point on the X axis (horizontally). Rotate the Adjust { knob to shift the starting point on the Y axis (vertically).

5. Press the Next button. The Logo Type submenu appears.

ISS 506 Integration Seamless Switcher • Operation 3-33