Installation, cont’d
Video signal output connections
4 Composite video output connectors — Connect composite |
video displays to these two female BNC connectors. |
7RCA audio connectors — Connect unbalanced stereo audio inputs to these RCA connectors. See figure
5 |
two |
Audio signal input connections
6 3.5 mm, |
and unbalanced stereo audio inputs to these sockets using |
connectors which are included with each MMX SVA switcher |
(you must supply the audio cable). See figure |
Tip (+)
Sleeve ()
Tip (Signal)
Right Channel
(Red Jacket)
Sleeve (Gnd )
Left Channel
(White Jacket)
illustration on how to wire a connector for the appropriate input |
type and impedance level. |
600 ohms
Tip | Tip | Tip |
Sleeve | Ring | Ring |
| Sleeve (s) | Sleeve (s) |
Tip | Tip | Tip |
Sleeve | Ring | Ring |
|
| 600 ohms |
Unbalanced Input | Balanced Input | Balanced Input |
(high impedance) | (high impedance) | (600 ohms) |
Figure 2-8 — Captive screw connector wiring for input
When making connections for the switcher from existing audio cables, see figure
The audio level for each input can be individually set, via
Tip | Sleeve | Tip (L) | Sleeve (Gnd) |
|
|
| Ring (R) |
| Tip (signal) |
| Tip (L) |
| Sleeve (Gnd) | Sleeve (Gnd) | |
| Unbalanced mono |
| Unbalanced stereo |
Figure 2-9 — Phono audio connectors
Figure 2-10 — RCA connector wiring
Audio signal output connections
83.5 mm,
Tip | Tip |
See Caution | Ring |
Sleeve | Sleeve (s) |
Tip | Tip |
See Caution | Ring |
Unbalanced Output | Balanced Output |
Figure 2-11 — Captive screw connector wiring for audio output
CAUTION | Connect the sleeve to ground (Gnd). Connecting |
| the sleeve to a negative |
| audio output circuits. |
9RCA audio connectors — Connect unbalanced stereo audio outputs to these RCA connectors. See figure
By default, the audio output follows the video switch. Audio breakaway, commanded via the
MMX 42/62 Series Matrix Switchers • Installation | MMX 42/62 Series Matrix Switchers • Installation |