Video Configuration

Extron electronic MLS 406MA, MLS 304SA, MLS 304MA, MLS 406SA manual Video Configuration

-10 dBV sensitivity

Quick Start — MLS 304MA, MLS 406, MLS 406MA, cont’d

Step 8

Connect all the devices’ power cords, and power on the system.

Step 1

Via RS-232, configure the MLS: select the video

4a. Enter setup mode: press and hold an in- put button for 3 seconds. The input’s LED blinks.

4b. Adjust audio levels: while still holding the input button, rotate the Volume knob until the Mid/normal LED lights or blinks.

MLS 304MA, MLS 406MA, MLS 304SA, and MLS 406SA (amplified models)

Clip: a blinking/lit LED indicates that the

type for 15-pin HD inputs; See chapters 2, Installation and 4, Serial Communication.

MAX

level is set too high.

Step 2

Select a Monitor Output mode via the control software. See Monitor Output Modes on page 3-7 and chapter 4, Serial Communication.

Audio Configuration

Step 1

For the Lineout and Preamp outputs, select mono or stereo audio, and select ‑10 dBV (unbalanced) or +4 dBu (balanced) via RS‑232 control.

Default: -10 dBV.

MID	Normal: a blinking LED indicates that the level
MIN	is set properly for maximum power output.

Signal: when lit, this indicates that a signal of at least -20 dBV (-18 dBu) is detected at the input.

NOTE Increasing the audio level beyond the point at which the Mid/normal LED blinks may result in a distorted output signal.

NOTE In setup mode a blinking or lit Mid/normal LED indicates that the power amplifier is capable of delivering maximum power output.

NOTE You may not need to adjust the per-input gain, because the default input gain adjustment is set for consumer audio sources such as VCRs, DVD players, and laptop computers.

MLS 406 (nonamplified model)

Step 2

Via RS-232, set Aux/Mix to on or off. If the Aux/Mix input will be used, use a small screwdriver to adjust the Aux/Mix input level.

Step 3

Disconnect audio output devices.

Step 4

Select an input and set audio input sensitivities.

NAudio input sensitivity levels must be adjusted with an active audio signal.

Peak: if blinking/lit, the level is set too high.

MAX	Normal: if blinking/lit, the output level at the
MID	Lineout and Preamp connectors is near the
MIN	specified output level of -10 dBV or +4 dBu.

Signal: when lit, this indicates that a signal of at least -20 dBV (-18 dBu) is detected at the input.

4c. Release the input button to save the setting for that input.

4d. Repeat steps 4a through 4c for each input.

Step 5

Reconnect the output devices, and via RS-232 set the global treble and bass levels and turn on loudness control, if desired.

Mono Amplified Output

Projector Control

Speakers Projector

Extron	Extron or	System
MLS 406MA	Extron or	System
MLS 406MA	MediaLink	Control
MediaLink Switcher	Controller

			Laptop
			w/ Audio
DVD	VCR	Document Camera	PC
			PC