4.If you selected IP [LAN] in step 2, the IP Connection window appears.
Figure 12. IP Connection Window
a.Examine the Matrix IP Address field, which displays the last Matrix IP address entered.
If necessary, enter the correct IP address in the field.
NOTE: 192.168.254.254 is the
b.If the switcher is
c.Click Connect. The Matrix Switchers Control Program is ready for operation.
Accessing the HTML Pages
Another way to configure and operate the switcher is via its
Configuring for Network Communication
The first time you connect a PC to the LAN port of a switcher, you may need to temporarily change the IP settings of the PC in order to communicate with the controller. Then you must change the default settings of the controller (IP address, subnet mask, and [optional] administrator name and password) in order to use the unit on an intranet (LAN) or on the Internet. After you have set up the DMS matrix switcher for network communication, you can reset the PC to its original network configuration.
NOTE: The computer and the switcher must both be connected to the same subnet on a LAN (using a
Use the ARP command to configure the IP address as follows:
1.Obtain a valid IP address for the DMS matrix switcher from the network administrator.
2.Obtain the MAC address (UID #) of the switcher from the label on its rear panel. The MAC address should have this format:
3.If the switcher has never been configured and is still set for factory defaults, go to step 4. If not, perform a mode 4 system reset. For detailed information on reset modes, see “Reset Operations” in the DMS Series Matrix Switchers User Guide.
NOTE: The switcher must be configured with the factory default IP address (192.168.254.254) before the ARP command is executed, as described below.
4.At the PC, access the
After receiving the arp
NOTE: You must ping the DMS matrix switcher as shown in step 5 for the IP address change to take place. The response should show the new IP address, as shown in the following figure.
24 DMS 1600, DMS 2000, DMS 3200, DMS 3600 • Remote Control | DMS 1600, DMS 2000, DMS 3200, DMS 3600 • Remote Control 25 |