Extron electronic 68-1316-02 manual Reset, Upload Firmware

Command	ASCII Command	Response	Additional Description
	(Host to Unit)	(Unit to Host)
Information Requests
Request information	I	V X! • A X! • F X$ • Vmt X@ • Amt X@ ]
			Show the selected video inputs,
			audio inputs (audio models only),
			switch mode, video muting status,
			and audio muting status (audio
			models only).
			X! = input number: 1 through the
			number of inputs on the switcher.
			0 = all inputs muted.
			X@ = muting status:
			1 = muted
			0 = unmuted
			X$ = switch mode:
			1 = normal switch mode
			2 = auto-input switch mode
Example:	I	V6 A6 F2 Vmt0 Amt0 ]
			On an SW6 DVI A Plus, video
			input 6 and audio input 6 are
			selected, auto-input switch mode is
			enabled, and neither the video nor
			the audio is muted.
Request part number	N	60-nnn-nn ]	Show the switcher part number.
			(See “Included Parts” in
			the “Reference Information” section
			for model part numbers.)
Query firmware version	Q	X# ]	Show firmware build number X#,
			expressed to the second decimal
			place.
Example:	Q	1.01 ]
Query EQ DIP switch status	41 S	Dip X@ • X@ ... X@ ] Show equalization on/off status
			for all inputs (inputs are shown in
			numerical order).
			X@ = Input EQ DIP switch setting:
			1 = on (up)
			0 = off (down)
NOTE: This command is case-sensitive.
Example:	41S	Dip 1 1 0 0]	On an SW4 DVI Plus, the Input EQ
			equalization DIP switches for inputs 1
			and 2 are set to On; the DIP switches
			for inputs 3 and 4 are set to Off.
Query auto-input switching status	72 #	Asw X@ ]	Show On and Off status of
			auto-input switching. For X@:
			0 = disabled
			1 = enabled
Reset
Reset	E ZXXX }	Zpx ]	Reset the switcher to factory default
			values. EDID is set to 1024x768 @
			60 Hz.
Upload Firmware
Upload firmware	E Upload }	...go	Upload a new firmware version from
		Upl ]	the computer. Upl appears after
			upload is complete.

SW DVI Plus Series • Remote Configuration and Control 22