Extron electronic SW DVI A Series user manual Furniture mounting

Installation, cont’d

Attaching the back of the rack mounting brackets to the SW2/SW4 switcher

4. Repeat steps 2 and 3 on the other side of the unit.

5. Mount the switcher to the rack support, using the two included rack screws.

IR

1

2

3

4 INPUTS

5

6

7

8

1

2

3

4OUTPUTS

5

6

7

8

ENTER

PRESET

Furniture mounting

To mount the SW DVI A switcher under a desk, table, or podium, use the optional VersaTools MBU 123 Mini Under-Desk Mounting Kit (part #70-212-01), as follows:

1. If rubber feet were previously attached to the bottom of the unit, remove them.

2. Remove the two screws from one side of the SW2/SW4. Retain the screws for possible later reassembly.

3. Attach one bracket to the side of the unit, using the provided machine screws.

Preparing the SW2/SW4 for under-desk mounting

4. Repeat steps 2 and 3 on the other side of the SW2/SW4.

5. Hold the unit with the attached brackets against the underside of the table or other furniture. On the mounting surface, mark the location of the brackets’ screw holes.

6. Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm) deep, into the mounting surface at the marked screw locations.

7. Insert #8 wood screws into the four pilot holes. Tighten each screw into the mounting surface until slightly less than 1/4" of the screw head protrudes.

8. Align the mounting screws with the slots in the brackets and place the unit against the surface, with the screws

AV

VID

AUD

MAV	SE
MA
I/OTRIX	RIE
+dB	SWITCHER
-dB
AUDIO	SETUP

through the bracket slots.

9. Slide the unit slightly forward or back, then tighten all four screws to secure it in place.

Mounting the SW2/SW4 to a back of the rack support

2-6 SW DVI A Series • Installation

SW DVI A Series • Installation 2-7