Extron electronic SW DVI A Series user manual Specifications, Part Numbers, Accessories

Specifications, Part Numbers, Accessories

Specifications

Video

Video amplifier bandwidth	1.65 Gbps
Pixel clock frequency	24 MHz to 165 MHz
Impedance	100 ohms
Resolution	Up to 1080p (HDTV) or 1920x1200
	(highest resolution of the single link DVI
	standard @ 60 Hz)

Video input

Number/signal type	2 or 4 single link DVI-D digital component
	video, 1920x1200 @ 60 Hz maximum
	resolution
Connectors	2 or 4 female DVI-I
Nominal levels
Digital video	1.2 Vp-p
DDC (Display Data Channel)
	TTL: 5.0 Vp-p
Equalization	+6 dB or +12 dB, switch selectable for each
	input

Video output

Number/signal type	1 DVI-D digital component video,
	1920x1200 @ 60 Hz maximum resolution
Connectors	1 female DVI-I

Audio

Gain	Unbalanced output: +0dB;
	Balanced output: +6 dB
Frequency response	20 Hz to 20 kHz, ±.05 dB
THD + Noise	0.01% @ 1 kHz at nominal level
S/N	>90 dB at maximum output (unweighted)
Crosstalk	<-45 dB @ 20 kHz;
	-72 dB @ 1 kHz or below
Stereo channel separation	>80 dB @ 20 Hz to 20 kHz

Audio input

Number/signal type	2 or 4 stereo, unbalanced
Connectors	(2 or 4) 3.5 mm mini audio jacks
	(tip = L, ring = R, sleeve = GND)
Impedance	>10k ohms unbalanced, DC coupled
Nominal level	-10 dBV (316 mVrms)
Maximum level	+8.2 dBV, unbalanced at 1% THD+N

N0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0dBV 2dBu

Audio output

Number/signal type	1 stereo, balanced/unbalanced
Connectors	(1) 3.5 mm captive screw, 5-pole
Impedance	50 ohms unbalanced, 100 ohms balanced
Maximum level (Hi-Z)	>+16.5 dBu, balanced;
	>8.2 dBV, unbalanced at 1% THD+N
Maximum level (600 ohm)	>+10.4 dBm, balanced;
	7.1 dBm, unbalanced at 1% THD+N

Control/remote

Serial control port	(1) RS-232, 3.5 mm captive screw
	connector, 5-pole (shared with
	autoswitching control)
Baud rate and protocol	9600 baud, 8 data bits, 1 stop bit, no parity
Serial control pin configurations.	1= TX, 2 = RX, 3 = GND
Contact closure	(1) 3.5 mm captive screw connector, 5-pole
	(shared with RS-232)
Contact closure pin configurations
	Pins 4 and 5 shorted together enable
	autoswitch mode.
IR remote control	IR 102 Remote Control
	(#70-224-10, optional)
Program control	Extron’s Simple Instruction Set (SIS™)

General

External power supply	100 VAC to 240 VAC, 50/60 Hz, external;
	to 12 VDC, 1 A, regulated
Power input requirements	12 VDC, 0.7 A
Temperature/humidity	Storage: -40 to +158 °F (-40 to +70 °C) /
	10% to 90%, noncondensing
	Operating: +32 to +122 °F (0 to +50 °C) /
	10% to 90%, noncondensing
Cooling	Convection, no vents

A-2 SW DVI A Series • Specifications, Part Numbers, Accessories SW DVI A Series • Specifications, Part Numbers, Accessories A-3