Extron electronic SW DVI A Series user manual Four, SIS Configuration and Control

Page 19

Operation, cont’d

9. On the Choose Firmware File window, double-click on the new firmware file to open it. The Choose Firmware File window closes, and the path to the selected firmware file is displayed in the “Select a firmware file” field on the firmware file selection screen.

10. Click the Upload button. A status bar, which shows the progress of the upload, appears in the Firmware Loader window. The firmware upload to the switcher may take several minutes. Once the status bar has progressed fully from left to right, the firmware loader utility resets the switcher.

In addition, messages appear on the firmware file selection window indicating when the unit is uploading the firmware, then resetting itself.

When the firmware upload process is completed, the message “Transfer Complete!” is displayed, and the new firmware version number appears in the Current Unit Information field.

11. Click Exit to close the Firmware Loader.

SW DVI A Series

Chapter4Four

SIS Configuration and Control

Host-to-Switcher Communications

Using the Command/Response Table

Command/Response Table for SIS Commands

3-10 SW DVI A Series • Operation

Image 19

Contents User’s Manual DVI and Audio SwitchersExtron’s Warranty PrecautionsFCC Class a Notice 安全须知中文Table of Contents Introduction Table of Contents, cont’dSW DVI a Series About the SW DVI a Series FeaturesIntroduction About this ManualIntroduction, cont’d Application Diagram InstallationExtron Tabletop use InstallationInstallation Overview Mounting the SW DVI a SeriesBack of the rack mounting Installation, cont’dPreparing the SW2/SW4 for under-desk mounting Furniture mountingSW2 DVI a rear panel Installation, cont’d Rear Panel FeaturesPin Signal Installation, cont’d Wiring the Power ConnectorDVI-I Video Connectors Audio ConnectorsAudio output Wiring the Remote/Autoswitching ConnectorWiring for RS-232 Enabling autoswitchingOperation ThreeOperations Front Panel FeaturesPowering on the switcher OperationRemote control buttons Using the IR 102 remote controlLocking IR remote access Enabling front panel lockout executive modeDownloading the firmware Setting equalization for input sourcesResetting Updating FirmwareOn the first screen that appears, select the RS-232 tab Loading the firmware to the switcherFour SIS Configuration and ControlHost-to-Switcher Communications SIS Configuration and ControlUsing the Command/Response Table Input selection Command/response table for SIS commandsSIS Configuration and Control, cont’d Specifications, Part Numbers AccessoriesSpecifications Specifications, Part Numbers, AccessoriesAccessories Specifications, Part Numbers, Accessories, cont’dIncluded Parts Cables Part numbers