Extron electronic TPS150 manual Receiver connections, Power connection, UTP Link Input connection

Page 18

Installation, cont’d

8RS-232 port — Connect a host device, such as a computer or touch panel control, to the TPT150 transmitter via this 9-pin D connector and a null modem serial port cable for serial RS-232 control (figure 2-6).

TPS150

Connected

 

 

 

RS-232

Function

 

 

pin

device pin

5

1

1

—

Not used

 

 

2

RX

Receive data

 

 

3

TX

Transmit data

9

6

4

—

Not used

Female

5

Gnd

Signal ground

 

 

6

—

Not used

 

 

7

—

Not used

 

 

8

—

Not used

 

 

9

—

Not used

 

 

Figure 2-6 — Remote port pin assignments for the TPT150 and TPR150

See chapter 4, “Serial Communications”, for definitions of the ASCII commands and instructions to install and use the control software.

Power connection

9AC power switch — Toggle the AC power switch to the on ( ) position to turn on the transmitter.

10AC power connector — Plug a standard IEC power cord into this connector to connect the transmitter to a 100 to 240VAC, 50 Hz to 60 Hz power source.

Receiver connections

All receiver connectors are on the rear panel (figure 2-7).

VIDEO OUTPUT

COMPOSITE

UTP LINK

RGB / VGA

S-VIDEO

SKEW ADJ

COMPONENT

90-260VAC; 0.25A; 47-63Hz

RS-232 PORT

 

RED BLUE GRN

 

R-Y

Y

B-Y

 

 

 

 

 

 

 

 

 

 

 

 

 

FUSE: 1.6A; 250V; TIME DELAY

11

12

13

14

15

16

17

Figure 2-7 — TPR150 receiver rear panel connectors

UTP Link Input connection

11Input UTP Link connector — Connect the free end of the TP cable from the transmitter to this RJ-45 female connector on the receiver.

See “TP Cable Termination”, on page 2-8, to properly wire the RJ-45 connector.

The TPS150 works with either shielded or unshielded cables. However, to comply with FCC rules, shielded (STP or FTP) cables must be used.

2-6 TPS150 Switching and Transmission System • Installation

Page 17 Page 19
Image 18
Page 17 Page 19
Contents TPS150 Precautions TPS150 Switching and Transmission System Quick Start QS-1 Inputs 1 and 2 Connect two RGB video sourcesInputs 3 QS-2 TPS150 Switching and Transmission System Quick Start Quick Start TPS150 Switching and Transmission SystemVolume and buttons Output 1 Connect aTable of Contents Table of Contents, cont’d One Introductiontroduction, cont’d About the TPT150 switching transmitterTPS150 Switching and Transmission System Introduction About this ManualComponent video Y, R-Y, B-Y on three female RCA connectors Serial RS-232 commands on one male DB9 connectorAbout the TPR150 receiver TP Cable Advantages FeaturesIntroduction, cont’d Transmission distanceTPS150 Switching and Transmission System Introduction Introduction, cont’d Two Installationstallation, cont’d Mounting the Transmitter and ReceiverRack mounting the transmitter Projector mounting the receiver Projector mounting the receiverTransmitter connections Installation, cont’dCabling and Rear Panel Views Video and audio input connectionsRemote control connections TP and audio output connectionsPower connection Receiver connectionsUTP Link Input connection Video output connections Serial connectionTP Cable Termination RJ-45Three TPS150 Switching and Transmission System Operation Controls and IndicatorsTransmitter controls and indicators Operationeration, cont’dReceiver controls and indicators TPR150 receiver front panelOperation, cont’d PowerProjector power OperationsReceiver reset Volume adjustmentFull system reset Output volumeOptimizing the Video Troubleshooting General checksDistorted image Specific problemsProblem Possible cause Solution No image appears AppearsFour ICS100 Windows-Based Control Program Installing the softwareSerialCommunicationsunications, cont’d System requirementsEstablishing communications with the program ICS100 program window and connected messageSerial Communications, cont’d AgainConnected window Using the software to configure the serial port settings Using the software to program the input and projector codes For each input or projector code to be programmedCode entry Ascii code Using the software to operate the transmission system Window appears figureUsing the help system Button mutes and unmutes the audio outputCommunication protocols Serial CommandsCommand and response structure Addressing the transmitterR0addressecho of the command sent Using the command/response tableSymbols R1addressecho of the command sentSpaces between bytes are not allowed Command Ascii Command Response Additional description AddressingInput audio level Command Response Additional descriptionFront panel lockout Serial Communications, cont’d AAppendix a Specifications Reference InformationSync Reference Information, cont’d Control projector TPR onlyPart Numbers Optional accessoriesAccessory Part number Included partsReference Information, cont’d FCC Class a Notice Extron’s Warranty Asia JapanExtron Electronics, USA
Related manuals
Manual 52 pages 17.77 Kb

TPS150 specifications

The Extron TPS150 is a highly regarded touch panel system designed for professional AV environments, providing an intuitive interface for controlling various audio and video components. This device is part of Extron's popular TouchLink Pro series, which is known for its robustness and versatility in managing classroom and conference room technology.

One of the standout features of the TPS150 is its high-resolution capacitive touch screen, which measures at 15 inches. This screen delivers vibrant colors and exceptional clarity, ensuring that users can easily interact with the device even in well-lit environments. The touch panel's interface is fully customizable, allowing users to create a layout tailored to their specific needs. This customization can include the addition of buttons, sliders, and dynamic graphics that make navigation seamless and user-friendly.

In terms of connectivity, the TPS150 supports Ethernet communication, which enables easy integration with networked AV systems. This feature allows for remote access and control, making it easier for IT professionals to monitor and manage AV devices from a centralized location. Additionally, the TPS150 is compatible with various Extron control systems, providing a robust platform for managing complex multimedia setups.

The device also incorporates advanced security features, ensuring that sensitive system controls are protected from unauthorized access. Administrators can establish user permissions and authentication processes to maintain control over the AV environment, which is particularly important in corporate and educational settings.

Moreover, the TPS150 supports Extron's global configurator software, which simplifies the setup process and allows for easy programming of touch panel interfaces. Users can design custom layouts quickly and efficiently, and the software also provides an extensive library of drivers for popular AV equipment, enhancing compatibility and functionality.

With its elegant design, high-quality components, and customizable interface, the Extron TPS150 touch panel offers an effective solution for AV control. Whether used in educational, corporate, or professional environments, it empowers users to streamline their audiovisual experiences and maintain effective control over their technology, ensuring successful presentations and meetings.
Top Page Image Contents