Extron electronic TPS150 manual Serial Communications, cont’d, Again

Serial Communications, cont’d

The transmitter’s serial port is factory-configured to 9600 baud, no parity, no flow control, half-duplex mode. If desired, the computer’s serial port settings can be changed from within the ICS100 program.

2. Click Communications > Comm Port > Comm 1 (or the correct Comm port). The Serial Port setup window appears (figure 4-3).

Figure 4-3 — Serial Port setup window

3.	Click in the appropriate radio buttons to select the desired settings for the
	computer connected to the transmitter.
4.	Click OK.
5.	Click Inline Model > Select Address. The Addresses window (figure 4-4)
	appears.

Figure 4-4 — Addresses window

		The transmitter must be addressed before it will accept and respond to
		commands. The addressing operation routes setup information to a particular
		unit on a network and enables command responses. Once the transmitter is
		addressed, it can accept an unlimited number of commands. If a different unit
		is addressed, the TPS150 ignores subsequent commands until it is addressed
		again.
		The factory-installed default address is 97, but this number can be changed.
		The transmitter can also take commands after receiving a broadcast address of
		00, but it does not send responses. Broadcast addressing is for multiple units
		on a network serial line in half-duplex mode.
6.	Click and drag on the slider or click the scroll up ( ) or scroll down ( )
	button until the desired address is visible.
7.	Click on the desired address. The default address is 97.
8.	Click OK.

4-4 TPS150 Switching and Transmission System • Serial Communications