Model 8/10 PLUS Introduction and Specifications
Description of Features
Outputs – Because switching is direct, the output will always have the same format as the selected input. Separate output connectors are provided for RGBS,
300 MHz Bandwidth – The wide bandwidth allows signals to be passed without loss of resolution. This is extremely important when using high resolution computer workstations.
Triple Action SwitchingTM (RGB Delay) – Triple Action SwitchingTM is a technique in which the RGB video is blanked for a brief period when a new input is selected. This prevents a distorted image from being displayed during the time the display device sync circuitry is locking onto the new sync input. When an input is selected,
1.Drop the RGB video signals leaving sync connected.
2.Wait for 20 mS and then switch to the new sync signal.
3.Wait for the time delay set by the user (0.0 - 7.5 seconds) and then switch to the new RGB signals. (During this time the projector is setting up to match the new sync.)
Switcher Control – Each channel of the switcher can be controlled in any one of the following ways:
1.Front Panel Buttons.
2.Manual Remote Control Connector –
3.
Internal Power Supply – The Model 8/10 PLUS switchers have an internal,
Rear Panel LED Indicators – Rear panel LEDs indicate which input is selected and which outputs are active.
The Model 10 PLUS front and back panels are shown below.
1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 1 0 |
Extron • Model 8 PLUS & Model 10 PLUS Switchers • User’s Manual | Page |