Installation, cont’d
5b. If you are using a wall box, insert the wall box into the opening, and attach it to the wall stud or furniture with nails or screws, leaving the front edge flush with the outer wall or furniture surface (figure
Wall Stud
Installation
Cable
Cable Clamp
Screws or Nails
Wall opening flush with
edge of box
Figure 2-3 — Attaching a wall box to a stud
If attaching the wall box to wood, use four #8 or #10 screws or
If attaching the wall box to metal studs or furniture, use four #8 or #10
6. If you are using a mounting bracket, follow the directions, if any, that came with the mounting bracket to attach the
clips that fasten the ring to the wall or furniture (figure 2- 4).
| Wall |
| Extron |
Push Mounting | IN9181 Wall |
Tabs Forward | Mounting Bracket |
Figure 2-4 — Attaching a mounting bracket to a wall
Device Configuration
|
| The rear of the control panel module will be inaccessible |
|
| after installation. |
1. | Cable the control panel module and set the DIP switches. | |
| See Rear Panel Setup in this chapter. | |
2. | Program the buttons. See chapter 4, Serial Communications, | |
| to program the control panel module. | |
3. | Test the control panel module before installing it into the | |
| wall box. |
CTL208CM Control Panel Module • Installation | CTL208CM Control Panel Module • Installation |