Quick Start Guide — CTL208CM, cont’d
Step 10
If the rear of the control panel module will be inaccessible when the installation is complete, the module should be powered up and its operation should be tested before the final installation.
Apply or connect power to all devices in the system.
Step 11
Test the system: Ensure that the controlled device responds as desired to the control panel module buttons. Correct the programming or system wiring as necessary. Ensure that you remove electrical power if you need to change the system wiring.
Step 12
Mount the control panel module into any Extron
If the rear of the control panel module will be inaccessible when the installation is complete, all cables, including the power connector on the CTL208, must be connected before the permanent installation.
Step 13
Mount the
Step 14
Restore power to all devices. The installation is now complete.
Table of Contents
Chapter 1 • Introduction | |
About the CTL208CM | |
Features | |
Chapter 2 • Installation | |
Installation Overview | |
UL Requirements for Wall Box Installation | |
Wall Mounting Site Preparation | |
Device Configuration | |
Wall Mounting | |
Rear Panel Setup | |
Chapter 3 • Operation | |
Button Modes | |
Send Programmed Commands | |
Factory Reset | |
Chapter 4 • Serial Communications | |
ICS100 Windows Control Program | |
System requirements | |
Installing the software | |
Starting the program | |
Using the software to program the CTL208CM | |
Using the help system | |
Serial Commands | |
Communications protocols | |
Command and response structure | |
Addressing the unit | |
Control panel module responses | |
Using the command/response table | |
Symbols | |
Command/response table for programming the CTL208 ... |
CTL208CM Control Panel Module • Table of Contents | i |