Installation and Operation, cont’d
Blank plates (two single space and one double space) are included with the interfaces to cover unused spaces. Adapter plates must be ordered separately (see “AAP/MAAP Availability” in appendix A). They must also be attached to the faceplate and cabled before the interface is installed in the wall or furniture. The screws needed for installing the adapter plates are supplied (MAAPs), or built into the plates (AAPs), so no additional screws are needed.
1. Remove the blank plates from the interface by unscrewing the hex screws (MAAPs) or nuts (AAPs) that fasten the plates to the faceplate.
2. Attach the adapter plates to the faceplate with the provided hex screws (MAAPs) or captive washers and
3. Attach the output cables to the rear connectors of the adapter plates. Soldering will be required for some connectors. Attach foil and braided shields to ground connections.
Rear Panel Features and Cabling
6
7
8
2
3
9 | 4 | 15 | 5 |
Rear panel of the RGB 464xi interface