Onboard LAN device
Enabled | Enable Onboard LAN device function. (Default value) |
Disabled | Disable this function. |
USB Controller
Enabled | Enable USB Controller. (Default value) |
Disabled | Disable USB Controller. |
USB Legacy Support
Enabled | Enable USB Legacy Support. |
Disabled | Disable USB Legacy Support. (Default value) |
SiS Serial ATA Controller
Enabled | Enable SiS Serial ATA Controller.(Default value) |
Disabled | Disable SiS Serial ATA Controller. |
SiS Serial ATA Mode
IDE | Set SiS Serial ATA Mode to IDE. |
RAID | Set SiS Serial ATA Mode to RAID (Default value). |
Onboard Serial Port 1
Auto | BIOS will automatically setup the Serial port 1 address. |
3F8/IRQ4 | Enable onboard Serial port 1 and address is 3F8/IRQ4. (Default value) |
2F8/IRQ3 | Enable onboard Serial port 1 and address is 2F8/IRQ3. |
3E8/IRQ4 | Enable onboard Serial port 1 and address is 3E8/IRQ4. |
2E8/IRQ3 | Enable onboard Serial port 1 and address is 2E8/IRQ3. |
Disabled | Disable onboard Serial port 1. |
Onboard Serial Port 2
Auto | BIOS will automatically set up the Serial port 2 address. |
3F8/IRQ4 | Enable onboard Serial port 2 and address is 3F8/IRQ4. |
2F8/IRQ3 | Enable onboard Serial port 2 and address is 2F8/IRQ3. (Default value) |
3E8/IRQ4 | Enable onboard Serial port 2 and address is 3E8/IRQ4. |
2E8/IRQ3 | Enable onboard Serial port 2 and address is 2E8/IRQ3. |
Disabled | Disable onboard Serial port 2. |
Onboard Parallel Port
Disabled | Disable onboard LPT port. |
378/IRQ7 | Enable onboard LPT port and address is 378/IRQ7. (Default value) |
278/IRQ5 | Enable onboard LPT port and address is 278/IRQ5. |
3BC/IRQ7 | Enable onboard LPT port and address is 3BC/IRQ7. |
Parallel Port Mode
SPP | Use Parallel port as Standard Parallel Port. |
EPP | Use Parallel port as Enhanced Parallel Port. |
ECP | Use Parallel port as Extended Capabilities Port. (Default value) |
ECP+EPP | Use Parallel port as ECP & EPP mode. |
ECP Mode Use DMA
This option is available only when Parallel Port Mode is set to ECP or ECP+EPP. |
| |
3 | Set ECP Mode Use DMA to 3. (Default value) |
|
1 | Set ECP Mode Use DMA to 1. |
|
|
|
|
| - 37 - | BIOS Setup |