Gigabyte 5230, 5225 SATA/RAID/SCSI Boot Order, BootUpFloppySeek, FlexibleAGP, Init Display First

English

SATA/RAID/SCSI Boot Order

This function will available when Boot up device set at "SCSI".

This feature allows you to select the boot order Serial ATA, RAID or SCSI device.

SCSI	Select your boot device priority by PCI SCSI.
RAID	Select your boot device priority by RAID.
SATA	Select your boot device priority by Serial ATA.

BootUpFloppySeek

During POST, BIOS will determine the floppy disk drive installed is 40 or 80 tracks. 360K type is 40 tracks 720K, 1.2M and 1.44M are all 80 tracks.

Enabled	BIOS searches for floppy disk drive to determ ine it is 40 or 80 tracks. Note
	that BIOS can not tell from 720K, 1 .2M or 1.44M drive type as they are all
	80tracks.
Disabled	BIOS will not search for the type of floppy disk drive by track num ber . Note
	that there will not be any warning m essage if the drive installed is 360K.
	(Default value)

FlexibleAGP 8X

Auto	Autom atically set AGP transfer rate according to AGP com patibility and
	stability. (Default value)
4X	Set AGP transfer rate to 4X m ode no m atter what the AGP transfer rate the
	card is.

Init Display First

This feature allows you to select the first initiation of the monitor display from which card when you install an AGP card and a PCI VGA card on board.

PCI	Set initial display first to PCI slot. (Default value)
AGP	Set initial display first to AGP.

GA-7N400E( -L) Motherboard - 38 -

綳蘹鵖 鞢鏒 齇 飀 蠖韙櫡曚垾陼 韗む