Gigabyte GA-M57SLI-S4 user manual Enter= Continue R=Repair F3=Exit

Step 4:

When the next screen (Figure 19) appears, press ENTER to continue the SATA driver installation from the floppy disk.

Windows Setup

Setup will load support for the following mass storage device(s):

NVIDIA RAID CLASS DRIVER (required)

NVIDIA NForce Storage Controller (required)

*To specify additional SCSI adapters, CD-ROM drives, or special disk controllers for use with Windows, including those for which you have a device support disk from a mass storage device manufacturer, press S.

*If you do not have any device support disks from a mass storage device manufacturer, or do not want to specify additional mass storage devices for use with Windows, press ENTER.

S=Specify Additional Device ENTER=Continue F3=Exit

Figure 19

After the SATA controller driver installation is completed, you can proceed with the Windows 2000/XP installation.

WindowsXP Professional Setup

Welcome to Setup.

This port of the Setup program prepares Microsoft(R)

Windows (R) XP to run on your computer.

To set up Windows XP now, press ENTER.

To repair a Windows XP installation using

Recovery Console, press R.

To quit Setup without installing Windows XP, press F3.

Enter= Continue R=Repair	F3=Exit
	Figure 20

(Note: Each time you add a new hard drive to a RAID array, the RAID driver will have to be installed under Windows once for that hard drive. After that, the driver will not have to be installed.)

English

- 79 - Appendix