Gigabyte 7VM400M-RZ user manual FDD Floppy Connector, IDE1 / IDE2 IDE1 / IDE2 Connector

Page 14

English

4) FDD (Floppy Connector)

Please connect the floppy drive ribbon cables to FDD. It supports 360K, 1.2M, 720K, 1.44M and 2.88M bytes floppy disk types.

The red stripe of the ribbon cable must be the same side with the Pin1.

34 33

2 1

5) IDE1 / IDE2 (IDE1 / IDE2 Connector)

Please connect first hard disk to IDE1 and connect CD-ROM to IDE2.

The red stripe of the ribbon cable must be the same side with the Pin1.

4039

21

IDE1 IDE2

6) PWR_LED

PWR_LED is connect with the system power indicator to indicate whether the system is on/off. It will blink when the system enters suspend mode.

 

Pin No.

Definition

1

1

MPD+

 

2

MPD-

 

3

MPD-

7VM400M-RZ Motherboard

- 14 -

Image 14
Contents 7VM400M-RZ Motherboard 7VM400M-RZ Installing the motherboard to the chassis Preparing Your ComputerTable of Contents Features Summary Introduction7VM400M-RZ Motherboard Layout 7VM400M-RZBlock Diagram EnglishStep Hardware Installation ProcessSet System Jumper JP1 Install the Central Processing Unit CPU CPU InstallationInstall Memory Modules Install AGP Card Install I/O Peripherals CablesLine Out jack ` MIC In jackSysfan System Fan Connector ATX ATX PowerCpufan CPU Fan Connector FDD Floppy Connector IDE1 / IDE2 IDE1 / IDE2 ConnectorFpanel 2 x 10 pins Connector Faudio Front Audio ConnectorCdin CD In Connector Surcen Surround Center ConnectorSpdif Spdif Out Connector FUSB1 / FUSB2 Front USB Connector Comb COM B ConnectorGame Game Connector BAT Battery Clrcmos Clear CmosMain Menu Main Menu For example Bios Ver. F5Status Page Setup Menu / Option Page Setup Menu PnP/PCI Configuration Advanced Bios FeaturesPower Management Setup Load Fail-Safe DefaultsTime Standard Cmos FeaturesDate IDE Primary Master, Slave / IDE Secondary Master, SlaveHalt on Floppy 3 Mode Support for Japan AreaDrive a / Drive B MemoryPassword Check Advanced Bios FeaturesFirst / Second / Third Boot Device Integrated Peripherals USB Mouse Support On-Chip LAN Boot ROMParallel Port Mode Onboard Serial PortPower Management Setup PnP/PCI Configurations PC Health Status Frequency/Voltage Control Dimm OverVoltage Control Load Fail-Safe DefaultsLoad Optimized Defaults Set Supervisor/User Password ConfigurationsEnter PasswordSave & Exit Setup Exit Without SavingPictures below are shown in Windows XP Install DriversInstall Chipset Drivers Item Description Contact Us Taiwan HeadquartersChina Shanghai